Search

This article proposes a framework that uses analytical assessment of reliability to guide the expansion planning of power distribution systems (PDS) considering reliability criteria. The framework allows the estimation of reliability indices with and without the execution of expansion projects, thus supporting the decision-making process on investments in expansion projects. In the analytical assessment of reliability, failure rates of zones and restoration times are calculated from past data of interruptions in the primary distribution network. In addition, the estimated reliability indices are adjusted to historical values through failure rates proportionate to the length of each zone. To test and validate the proposed framework, it was applied to the distribution network at bus 5 of the Roy Billinton Test System (RBTS) and also to a real distribution feeder located in Brazil. The results indicated that the proposed framework can help define the most attractive investments leading to improvements in reliability indices and reduction in unsupplied energy. The estimation of reliability indices and energy not supplied, considered the following expansion alternatives: (i) the installation of normally-closed sectionalizing switches, (ii) the installation of normally-open switches with interconnection to adjacent feeders, (iii) the automation of switches, and (iv) the reconductoring of zones of the primary distribution network. Nevertheless, the proposed framework allows the inclusion of other expansion alternatives. Finally, the proposed framework proved to be handy and useful for real-life applications. [ABSTRACT FROM AUTHOR]

High impedance faults (HIFs) have been a major concern for protecting distribution systems and public safety hazards when involving downed conductors. The deployment of smarter grids brings new technologies for smart monitoring, automation, and protection of distribution networks. This paper presents a new method for a series of HIF detection and location in primary distribution feeders, using voltage unbalance measurements collected from smart meters (SMs) installed at low-voltage end-users. The methodology was tested in MATLAB and Simulink through steady-state simulations of a typical 13.8 kV distribution system, under load unbalance and different fault scenarios. Results show that the proposed method is robust and accurate for the detection of blown fuses and broken conductors, with or without ground faults, located either at the source or the load-side. The ease of implementation in SM design, formulation of parameters, and reliable simulation results show potential real-life applications. [ABSTRACT FROM AUTHOR]