Search

Solar photovoltaic self-consumption is an attractive approach to increase autarky and reduce emissions in the building sector. However, a successful deployment in urban rooftops requires both accurate and low-computational-cost methods to estimate the self-consumption potential and economic feasibility, which is especially scarce in the literature on net billing schemes. In the first part of this study, a bottom-up GIS-based techno-economic model has helped compare the self-consumption potential with net metering and net billing in a Mediterranean municipality of Spain, with 3734 buildings in total. The capacity was optimized according to load profiles obtained from aggregated real measurements. Multiple load profile scenarios were assessed, revealing that the potential self-sufficiency of the municipality ranges between 21.9% and 42.5%. In the second part of the study, simplified regression-based models were developed to estimate the self-sufficiency, self-consumption, economic payback and internal rate of return at a building scale, providing nRMSE values of 3.9%, 3.1%, 10.0% and 1.5%, respectively. One of the predictors with a high correlation in the regressions is a novel coefficient that measures the alignment between the load and the hours with higher irradiance. The developed correlations can be employed for any other economic or demand scenario. [ABSTRACT FROM AUTHOR]

As a result of the increase in city populations, and the high energy consumption and emissions of buildings, cities in general, and buildings in particular, are the focus of attention for public organizations and utilities. Heating is among the largest consumers of energy in buildings. This study examined the influence of the income of inhabitants on the consumption of energy for heating and the CO2 emissions in city buildings. The study was carried out using equivalized disposable income as the basis for the analysis and considered the economies of scale of households. The results are shown per inhabitant and household, by independently considering each city. Furthermore, to more clearly identify the influence of the population income, the study was also carried out without considering the influence of the climate. The method was implemented in the case of Spain. For this purpose, Spanish cities with more than 50,000 inhabitants were analyzed. The results show that, both per inhabitant and per household, the higher the income of the inhabitants, the greater the consumption of energy for heating and the greater the emissions in the city. This research aimed to help energy utilities and policy makers make appropriate decisions, namely, planning for the development of facilities that do not produce greenhouse gases, and enacting laws to achieve sustainable economies, respectively. The overall aim is to achieve the objective of mitigating the impact of emissions and the scarcity of energy resources. [ABSTRACT FROM AUTHOR]

Improving the energy performance of existing buildings is one of the main strategies defined by the European Union to reduce global energy costs. Amongst the actions to be carried out in buildings to achieve this objective is working with passive measures adapted to each type of climate. To assist designers in the process of finding appropriate solutions for each building and location, different tools have been developed and since the implementation of building information modeling (BIM), it has been possible to perform an analysis of a building's life cycle from an energy perspective and other types of analysis such as a comfort analysis. In the case of Spain, the first BIM environment tool has been implemented that deals with the global analysis of a building's behavior and serves as an alternative to previous methods characterized by their lack of both flexibility and information offered to designers. This paper evaluates and compares the official Spanish energy performance evaluation tool (Cypetherm) released in 2018 using a case study involving the installation of sunlight control devices as part of a building refurbishment. It is intended to determine how databases and simplifications affect the designer's decision-making. Additionally, the yielded energy results are complemented by a comfort analysis to explore the impact of these improvements from a users' wellbeing viewpoint. At the end of the process the yielded results still confirm that the simulation remains far from reality and that simulation tools can indeed influence the decision-making process. [ABSTRACT FROM AUTHOR]

The growing concern about global climate change extends to different professional sectors. In the building industry, the energy consumption of buildings becomes a factor susceptible to change due to the direct relationship between the outside temperature and the energy needed to cool and heat the internal space. This document aims to estimate the energy consumption of a Minimum Energy Building (MEB) in different scenarios—past, present, and future—in the subtropical climate typical of seaside cities in Southern Spain. The building energy consumption has been predicted using dynamic building energy simulation software tools. Projected climate data were obtained in four time periods (Historical, the 2020s, 2050s, and 2080s), based on four emission scenarios defined by the Intergovernmental Panel on Climate Change (IPCC): B1, B2, A2, A1F1. This methodology has been mathematically complemented to obtain data in closer time frames (2025 and 2030). In addition, different mitigation strategies have been proposed to counteract the impact of climate change in the distant future. The different energy simulations carried on show clearly future trends of growth in total building energy consumption and how current building designers could be underestimating the problem of air conditioning needs in the subtropical zone. Electricity demand for heating is expected to decrease almost completely, while electricity demand for cooling increases considerably. The changes predicted are significant in all scenarios and periods, concluding an increase of between 28–51% in total primary energy consumption during the building life cycle. The proposed mitigation strategies show improvements in energy demands in a range of 11–14% and they could be considered in the initial stages of project design or incorporated in the future as the impact of climate change becomes more pronounced. [ABSTRACT FROM AUTHOR]

The trend in energy consumption, with a particular focus on heating and cooling demand, is an issue that is relevant to the promotion of new energy policies and more efficient energy systems. Moreover, heating and cooling energy demand is expected to rise in the next several decades, mainly due to climate change as well as increasing incomes in developing countries. In this context, the building sector is currently a relevant energy-intensive economic sector in Morocco; it accounts for 33% of the country's total energy demand (as the sector with the second highest energy demand, after the transport sector), with the residential sector accounting for 25% and the tertiary sector accounting for 8%. Aiming to reduce energy dependence and promote sustainable development, the Moroccan government recently issued a comprehensive plan to increase the share of renewables and improve energy efficiency. This strategy includes novel thermal building regulations promoted by the Moroccan Agency for Energy Efficiency. This paper analyzes the thermal behavior and heating-cooling energy demand of a residential building located in Tangier (Morocco) as a case example, based on the country's new thermal regulations and considering specific climatological conditions. A comparison with common Moroccan residential buildings as well as with those in nearby countries with similar meteorological conditions but significant differences in terms of energy demand regulation and requirements, such as Spain, is also included. Simulations were carried out using the DesingBuilder and EnergyPlus Software packages. According to the results, the last building thermal regulation requirements in Morocco need to be revised and extended in order to achieve the energy efficiency objectives established by the Moroccan government for 2030. [ABSTRACT FROM AUTHOR]

New technological, societal and legislative developments are necessary to support transitions to low-carbon energy systems. The building sector is responsible for almost 36% of the global final energy and 40% of CO2 emissions, so this sector has high potential to contribute to the expansion of positive energy districts. With this aim, a new digital Geographic Information System (GIS) platform has been developed to quantify the energy savings obtained through the implementation of refurbishment measures in residential buildings, including solar thermal collectors and geothermal technologies and assuming the postal district as the representative unit for the territory. Solar resources have been estimated from recently updated solar irradiation maps, whereas geothermal resources have been estimated from geological maps. Urbanistic data have been estimated from official cadastre databases. For representative buildings, the annual energy demand and savings are obtained and compared with reference buildings, both for heating and cooling. The GIS platform provides information on average results for each postal district, as well as estimates for buildings with particular parameters. The methodology has been applied to the Asturian region, an area of about 10,600 km2 on the Cantabrian coast of Spain, with complex orography and scattered population, qualified as a region in energy transition. High rehabilitation potentials have been achieved for buildings constructed before the implementation of the Spanish Technical Building Code of 2006, being higher for isolated houses than for collective buildings. Some examples of results are introduced in specific localities of different climatic zones. [ABSTRACT FROM AUTHOR]

The trend in energy consumption, with a particular focus on heating and cooling demand, is an issue that is relevant to the promotion of new energy policies and more efficient energy systems. Moreover, heating and cooling energy demand is expected to rise in the next several decades, mainly due to climate change as well as increasing incomes in developing countries. In this context, the building sector is currently a relevant energy-intensive economic sector in Morocco; it accounts for 33% of the country's total energy demand (as the sector with the second highest energy demand, after the transport sector), with the residential sector accounting for 25% and the tertiary sector accounting for 8%. Aiming to reduce energy dependence and promote sustainable development, the Moroccan government recently issued a comprehensive plan to increase the share of renewables and improve energy efficiency. This strategy includes novel thermal building regulations promoted by the Moroccan Agency for Energy Efficiency. This paper analyzes the thermal behavior and heating-cooling energy demand of a residential building located in Tangier (Morocco) as a case example, based on the country's new thermal regulations and considering specific climatological conditions. A comparison with common Moroccan residential buildings as well as with those in nearby countries with similar meteorological conditions but significant differences in terms of energy demand regulation and requirements, such as Spain, is also included. Simulations were carried out using the DesingBuilder and EnergyPlus Software packages. According to the results, the last building thermal regulation requirements in Morocco need to be revised and extended in order to achieve the energy efficiency objectives established by the Moroccan government for 2030. [ABSTRACT FROM AUTHOR]

New technological, societal and legislative developments are necessary to support transitions to low-carbon energy systems. The building sector is responsible for almost 36% of the global final energy and 40% of CO2 emissions, so this sector has high potential to contribute to the expansion of positive energy districts. With this aim, a new digital Geographic Information System (GIS) platform has been developed to quantify the energy savings obtained through the implementation of refurbishment measures in residential buildings, including solar thermal collectors and geothermal technologies and assuming the postal district as the representative unit for the territory. Solar resources have been estimated from recently updated solar irradiation maps, whereas geothermal resources have been estimated from geological maps. Urbanistic data have been estimated from official cadastre databases. For representative buildings, the annual energy demand and savings are obtained and compared with reference buildings, both for heating and cooling. The GIS platform provides information on average results for each postal district, as well as estimates for buildings with particular parameters. The methodology has been applied to the Asturian region, an area of about 10,600 km2 on the Cantabrian coast of Spain, with complex orography and scattered population, qualified as a region in energy transition. High rehabilitation potentials have been achieved for buildings constructed before the implementation of the Spanish Technical Building Code of 2006, being higher for isolated houses than for collective buildings. Some examples of results are introduced in specific localities of different climatic zones. [ABSTRACT FROM AUTHOR]