Search

The metallurgical sector is one of the most emission- and energy-intensive industries. The possibility of using fossil carbon substitutes has been investigated to reduce the environmental impact of the steelmaking sector. Among others, biochar emerged as a promising fossil coal/coke substitute. We conducted a literature review on biochar use in the metallurgical sector and its potential environmental benefits. The possibility for biochar as a coal/coke substitute is influenced by the source of biochar production and the process within which it can be used. In general, it has been observed that substitution of biochar ranging from a minimum of 5% to a maximum of 50% (mostly around 20–25%) is possible without affecting, or in some cases improving, the process, in coke making, iron sintering, blast furnaces and electric furnaces application. In some studies, the potential CO2 reduction due to biochar use was estimated, ranging from 5% to about 50%. Despite there still being an area of further investigation, biochar appeared as a promising resource with a variety of uses in the metallurgical sector, contributing to the lowering of the environmental impact of the sector. [ABSTRACT FROM AUTHOR]

The recovery of livestock manure, rich in nutrients, as fertilizer in agriculture, could pose the risk of an excessive load of nitrogen on the soil. Ammonia stripping is one of the available technologies for reducing the amount of nitrogen in the digestate obtained by the anaerobic digestion of manure. The study investigated the performance and energy consumption of a full-scale ammonia-stripping plant, equipped with a bubble reactor and working without the use of any alkaline reagent under semi-batch conditions. Stripping tests were conducted on the liquid fraction of the digestate, studying the current and optimized operative conditions of the plant. The main variables influencing the process were pH, temperature, airflow, and feed characteristics. In the experimental tests, the pH spontaneously increased to 10, without dosing basifying agents. Higher temperatures favoured the stripping process, the higher tested value being 68 °C. The airflow was kept equal to 15 Nm3 h−1 m−3digestate in the pre-stripping and to 60 Nm3 h−1 m−3digestate in the stripping reactors, during all tests. The energy requirement was completely satisfied by the CHP (combined heat and power) unit fed with the biogas produced by manure digestion. Results showed anaerobic digestion coupled with stripping to be a suitable solution for removing up to 81% of the ammonium with neither external energy input nor reagent dosage. [ABSTRACT FROM AUTHOR]

The recent trend of turning wastewater treatment plants (WWTPs) into energy self-sufficient resource recovery facilities has led to a constant search for solutions that fit into that concept. One of them is chemically enhanced primary treatment (CEPT), which provides an opportunity to increase biogas production and to significantly reduce the amount of sludge for final disposal. Laboratory, pilot, and full-scale trials were conducted for the coagulation and sedimentation of primary sludge (PS) with iron sulphate (PIX). Energy and economic balance calculations were conducted based on the obtained results. Experimental trials indicated that CEPT contributed to an increase in biogas production by 21% and to a decrease in sludge volume for final disposal by 12% weight. Furthermore, the application of CEPT may lead to a decreased energy demand for aeration by 8%. The removal of nitrogen in an autotrophic manner in the side stream leads to a further reduction in energy consumption in WWTP (up to 20%). In consequence, the modeling results showed that it would be possible to increase the energy self-sufficiency for WWTP up to 93% if CEPT is applied or even higher (up to 96%) if, additionally, nitrogen removal in the side stream is implemented. It was concluded that CEPT would reduce the operating cost by over 650,000 EUR/year for WWTP at 1,000,000 people equivalent, with a municipal wastewater input of 105,000 m3/d. [ABSTRACT FROM AUTHOR]