Search

In this study, for the first time an advanced exergy analysis was applied to a solar hybrid food dehydrator to find out the causes of the inefficacies and to assess the actual improvement potential. The dryer was integrated with an evacuated solar tube collector and gas burner as a heating sources. Drying experiments were performed using bell pepper at 55 °C under three heating options i.e., gas, solar and dual. The rates of exergy destructions were split into unavoidable ( E d U N ) and avoidable ( E d A V ) which further split into four parameters termed unavoidable endogenous ( E d U N , E N ), unavoidable exogenous ( E d U N , E X ), avoidable endogenous ( E d A V , E X ) and avoidable exogenous (E d A V , E N ). Conventional exergy analysis revealed that drying chamber possess lower improvement potential rate (IP) than heating components while outcomes of advanced exergy analysis showed that both the design and system components interaction of heating unit imparted a major effect on its efficiency. Optimizing the operating conditions of the heating sources could reduce their higher amount of inefficiencies. The values of exergy efficiency for the overall system were calculated to be 86.66%, 84.18%, 83.74% (conventional) and 97.41%, 95.99%, 96.16% (advanced) under gas, dual and solar heating modes respectively. [ABSTRACT FROM AUTHOR]

This paper presents the results of a field study undertaken all over the Punjab, Pakistan, to evaluate the socio-economic and climatic impact of photovoltaic-operated high-efficiency irrigation systems (HEIS), i.e., drip and sprinkler irrigation systems. Nearly half of the rural population relies on agriculture for a living, and the recent energy crisis has had a negative impact on rural communities. Farmers' reliance on fossil fuels for the operation of irrigation systems has increased exponentially, resulting in the high costs of agricultural production. Primary data regarding on-farm agriculture and irrigation practices used in this study were collected through an intensive on-farm survey, while secondary data were taken from published reports and statistics. The results of the current investigation show that the installation of PV systems has resulted in the increased adoption of high-efficiency irrigation systems, a reduction in the high operational costs incurred on account of old diesel-powered pumping systems (with an annual saving of 6.6 million liters of diesel), a 100% increase in farmer's income, a reduction of 17,622 tons of CO2 emissions per annum, and 41% savings in water. The unit cost of PV-powered HEIS was found to be 0.1219 USD/kWh, which was 4% and 66% less than subsidized electricity cost and diesel cost, respectively. [ABSTRACT FROM AUTHOR]

Fossil fuels are being depleted, resulting in increasing environmental pollution due to greenhouse gases and, consequently, emerging detrimental environmental problems. Therefore, renewable energy is becoming more important; hence, significant research is in progress to increase efficient uses of solar energy. In this paper, the thermal performance of a conical concentrating system with different heat transfer fluids at varied flow rates was studied. The conical-shaped concentrator reflects the incoming solar radiation onto the absorber surface, which is located at the focal axis, where the collected heat is transported through heating mediums or heat transfer fluids. Distilled water and nanofluids (Al2O3, CuO) were used in this study as the heat transfer fluids and were circulated through the absorber and the heat storage tank in a closed loop by a pump to absorb the solar radiation. The efficiency of the conical concentrating system was measured during solar noon hours under a clear sky. The collector efficiency was analyzed at different flow rates of 2, 4, and 6 L/min. The thermal efficiency, calculated using different heat transfer fluids, were 72.5% for Al2O3, 65% for CuO, and 62.8% for distilled water. Comparing the thermal efficiency at different flow rates, Al2O3 at 6 L/min, CuO at 6 L/min, and distilled water at 4 L/min showed high efficiencies; these results indicate that the Al2O3 nanofluid is the better choice for use as a heating medium for practical applications. [ABSTRACT FROM AUTHOR]