Search

The increase in inverter-based resources associated with the increased installation of PV sources is a concern because it reduces the inertia of the power system during peak PV generation periods. As a countermeasure to reduce grid inertia, the addition of pseudo-inertia using virtual synchronous machines can be selected, and PV generation can cooperatively contribute to the stable operation of the power system by using the suppressed output as reserve power. However, few studies have analyzed VSMs that do not use batteries and use PV as a resource (PV-VSM) in simulations, including grid interconnection and solar radiation fluctuations, and it is necessary to clarify the issues and discuss countermeasures. In this study, electromagnetic transient response analysis was applied to a VSM connected to a two-generator system, simulations were performed, and the following findings were reported and countermeasure methods for the problem were proposed. When the PV capacity is insufficient for the output required by the VSM inverter, the PV-VSM control system may become unstable. This is caused by a drop in the capacitor voltage of the DC/DC converter due to insufficient PV output. The limiter control system is designed to address this problem by combining the headroom estimation system with the current limiting algorithm. The proposed limiter control system is validated on solar radiation ramp fluctuations as a test case and found that the system was effective in supressing PV-VSM instability. In our simulation case, the PV-VSM with our limiter control can continue to operate stably even if the PV available power is 0.03 [p.u.] short of the inverter's reference power by the solar power ramp fluctuation, as long as the inverter installation rate is less than 50%. [ABSTRACT FROM AUTHOR]

This paper describes the process of setting up an appropriate volt–var curve for the reactive power control of a photovoltaic (PV) inverter interconnected to a distribution line that is voltage controlled by a load ratio control transformer (LRT). Computer simulations with 360 patterns of volt–var curves applied to five actual distribution line models are presented. The number of patterns was narrowed down to 23 by using voltage, distribution-line loss, number of LRT tap operations, and a new evaluation index, the match ratio. When a power-factor constraint is imposed on the PV inverter, it may not output the reactive power according to the volt–var curve depending on the active power output. The match rate is an index to show the percentage of the operating points of the PV inverter that conform with the volt–var curve. By evaluating the match rate, it can be demonstrated if the PV inverter efficiently contributes to the voltage control, which greatly contributes to narrowing of the volt–var curve. It is demonstrated that the volt–var curve obtained using the proposed method is superior in terms of voltage controllability, distribution line losses, and the number of LRT tap controls. [ABSTRACT FROM AUTHOR]

Virtual inertia control is a methodology to make inverter-based resources (IBR) behave like a synchronous machine. However, an IBR cannot fully emulate the response of synchronous machine because of its low-current capacity. When the inertial response of an IBR is affected by the current limitation, the synchronization of the synchronous machine simulated virtually inside the IBR controller with the other synchronous generators in the grid is affected, which may cause step-out of the simulated generator. We propose a methodology which can keep the synchronization by modifying internal induced voltage of the simulated generator to follow the system voltage change. The proposal is validated by the simulation using a nine-bus transmission system model including two synchronous generators and a large-scale IBR. The result of the generator trip simulation shows that the proposed method suppresses the phase angle variation while the current is limited, and avoids the instability regarding the synchronism. Furthermore, the impact of the current limitation on frequency stability is also evaluated through the simulation study and it is found that as the amount of output suppression increases, the frequency nadir falls, but the rate-of-change of frequency is hardly affected. [ABSTRACT FROM AUTHOR]