Search

The stress threshold of deep reservoir shale subjected to fracturing fluid immersion is an important factor affecting fracture initiation and propagation during fracturing. However, little information has been reported on the effect on shale of soaking at high temperature and high pressure (HTHP). In this study, immersion tests and triaxial compression tests were carried out at reservoir temperature and in-situ stress on the downhole cores with different mineral compositions. The characteristics of stress thresholds, i.e., crack initiation stress ( σ c i ), crack damage stress ( σ cd ), and peak deviator stress ( σ p ), of shale affected by the different times of soaking with low-viscosity fracturing fluid (a) and the different viscosity fracturing fluids (a, b, and c) were investigated. The results show that hydration at HTHP has a significant softening effect on the stress thresholds ( σ c i , σ cd , σ p ) of reservoir shale, but the softening rate varies for samples with different mineral compositions. The crack initiation stresses of quartz-rich and clay-rich shales treated with different soaking times and different soaking media remain almost unchanged in the range of 47 to 54% of the corresponding peak strength, while the crack initiation stresses of carbonate-rich shales are significantly affected. The ratio σ cd / σ p of quartz-rich shale is significantly affected by the different viscosity fracturing fluids (a, b) and the different times of soaking with low-viscosity fracturing fluid (a), while clay- and carbonate-rich shales are less affected. The results of this study can provide a reference for the fracturing design of deep shale gas development. [ABSTRACT FROM AUTHOR]

This paper investigates the variation of mechanical properties of granite during temperature and stress cycling, which is an important part of evaluating the long-term thermal and mechanical stability of thermal energy storage. Cyclic temperature and loading tests were conducted where the upper limit of cyclic temperature was 100–600 °C, and the upper stress limits were 70% and 85% of the average uniaxial compressive strength (UCS) at the corresponding temperature. The response of stress–strain characteristics of the granite samples to changes in temperature, and cyclic load upper limit, while the number of temperature and loading cycles was comprehensively analyzed. The results show that the temperature and stress cycles have significant effects on the mechanical properties of granite (i.e., stress–strain curve, strength, elastic modulus, and deformation). The elastic modulus of the sample during loading increases gradually. The strain corresponding to the upper loads of the granite samples decreases with an increasing number of cycles. Additionally, the UCS of samples after 10 cycles at 70% loading stress is greater than that at 85% loading stress. The mechanical properties of samples change dramatically during the first and second cycles at 85% loading stress, whereas at 70% loading stress, the mechanical properties change gradually in the first few cycles, and then tend to stabilize. Cyclic hardening is observed at temperatures below 500 °C, where post cyclic UCS is greater than the uncycled average UCS. This phenomenon requires further research. [ABSTRACT FROM AUTHOR]