Search

The evaporation, autoignition and micro-explosion characteristics of RP-3 kerosene droplets under sub-atmospheric pressure (0.2–1.0 bar) and elevated temperature (473–1023 K) were experimentally investigated using high-speed camera technology. The results showed that the droplet evaporation rate increased monotonically with increasing temperature and pressure under 573–873 K and 0.2–1.0 bar. The decrease of temperature and pressure was obviously detrimental to the successful autoignition of droplets and increased the ignition delay time. Autoignitions at 0.2 bar were very difficult and required an ambient temperature of at least 973 K, which was about 150 K higher than the minimum ignition temperature at 1.0 bar. Sub-atmospheric pressure environment significantly inhibits the formation of soot particle clusters during the autoignition of droplet. Reducing pressure was also discovered to reduce the likelihood of micro-explosions at 673, 773 and 823 K but increase the bubble growth rate and droplet breakage intensity. Strong micro-explosions with droplet breakage time close to 1 ms were observed at 0.6 bar and 773/823 K, showing the characteristic of bubble inertia control growth. [ABSTRACT FROM AUTHOR]

In recent years, water (R718) as a kind of natural refrigerant--which is environmentally-friendly, safe and cheap--has been reconsidered by scholars. The systems of using water as the refrigerant, such as water vapor compression refrigeration and heat pump systems run at sub-atmospheric pressure. So, the research on water boiling heat transfer at sub-atmospheric pressure has been an important issue. There are many research papers on the evaporation of water, but there is a lack of data on the characteristics at sub-atmospheric pressures, especially lower than 3 kPa (the saturation temperature is 24 °C). In this paper, the experimental research on water boiling heat transfer on a horizontal copper rod surface at 1.8-3.3 kPa is presented. Regression equations of the boiling heat transfer coefficient are obtained based on the experimental data, which are convenient for practical application. [ABSTRACT FROM AUTHOR]