Search

This paper investigates the climate change impact on cooling energy consumption of office buildings in four major architectural climate zones in China. The results show that there are apparent differences in the responses of monthly or yearly cooling loads to climatic change in different climates. Dominant factors affecting monthly cooling loads change from dry bulb temperature (DBT) to wet bulb temperature (WBT) with the climate zones changing from severe cold to hot. The yearly cooling load was mainly afftectd by DBT in severe cold climate, whereas the WBT had the dominant effect in the other climates. With the continuous warming climate, the yearly cooling load did not rise significantly for any climate zone except for severe cold climate zone where cooling load had a significant increase ( p  < 0.01). More importantly, the cooling load showed a weak decrease in Guangzhou. These results suggest that different measurements for buildings cooling energy conservation should be made in different climate zones. The humidity effect should be fully considered to improve buildings energy efficiency, especially in the hot climate zones. The continuous increase of temperature in the future does not necessarily increase cooling loads of buildings in the cold, hot summer & cold winter and hot summer & warm winter climate zones, and change trendency of humidity in the future need to be considered to predict cooling energy consumption. [ABSTRACT FROM AUTHOR]

Abstract: In Hong Kong, conventional air-conditioning (AC) systems cause a high energy consumption and poor indoor thermal comfort. This paper investigated the AC load profiles of three typical local commercial buildings, i.e. office, hotel and retail, and examined the energy consumption of liquid desiccant cooling system (LDCS) for these buildings. Simulation results showed that the cooling load contributed to more than 98% of total annual load, with high latent load proportion from March to September. The high reheating ratio, i.e. from 60% to 90%, is found to be the main reason for the poor thermal comfort. Therefore, the LDCS which could handle sensible and latent loads separately was proposed. However, the electricity-driven LDCS was found not suitable for local commercial buildings. significant energy saving could be achieved by the solar-assisted LDCS system with thermal storage, when the installation area for solar collectors is larger than the minimum required one, i.e. 9.7m2/(kWm−2) for office and 12.7m2/(kWm−2) for hotel buildings. Energy saving of different system types with different installation areas was also studied. The solar-assisted LDCS shows more energy saving in winter but less in summer. Results and conclusions can be useful for researchers and local engineers. [Copyright &y& Elsevier]

Abstract: The shading-type building-integrated photovoltaic (BIPV) claddings can act as power generators as well as external shading devices of a building, which reduce the energy consumption of the building. However, there is little information about energy impacts of different tilt angles of the shading-type BIPV claddings. By considering the typical meteorological conditions of Hong Kong, the energy performance of the shading-type BIPV claddings, in terms of the electricity generation and the cooling load reduction, is analyzed in this paper. The optimum tilt angle of PV modules for maximum electricity generation is found to be 20° instead of local latitude. Combining electricity generation and cooling load reduction, it can be concluded that the optimum tilt angles for the first type of the shading-type BIPV claddings vary from 30° to 50°, while the optimum tilt angle for the second type is 0°. [Copyright &y& Elsevier]