Search

District heating system brings with it the problem of achieving a fair billing service for heating of apartment buildings in the case of uneven temperature in them. The problem is most pronounced when the individual apartments are completely excluded from the heating system of the building. The model of an existing building with 24 apartments was simulated in the software EnergyPlus, for different characteristics of the thermal envelope and different conditions of use, when the apartment with the lowest energy consumption is excluded from the heating system. It was simulated the exclusion of this apartment in which people are present and the lights and electrical appliances are turned on and in which there is no presence of people and electricity consumption (the apartment is empty). As a measure of energy flow between unheated and adjacent apartments, the parameter “stolen” energy is defined. The results of the conducted simulations show that the stolen energy is reduced by the exterior and interior insulation of the building. In this paper, data on energy flow when there is interior insulation in apartments, in particular according to the current regulations in Serbia, are especially analyzed. The results show that, depending on the case and scenario, the stolen energy ranges from 27.23 to 7.97 kWh/m 2 . The insulation of interior walls of the building can significantly mitigate the problem of energy flow due to temperature differences between apartments. [ABSTRACT FROM AUTHOR]

• Freely available online overview of district heating efficiency indicators. • Hourly district heating energy use data from approx. 43 000 buildings. • Building stock segmented into building typologies for analysis of: • -1) Heating energy use intensity, 2) load variation and 3) cooling efficiency This paper provides a state-of-the-art and freely available online overview of the district heating (DH) efficiency of Danish building typologies. The overview is based on DH consumption data from 42 969 buildings constructed up until 2017 that in combination with data from the Danish Building and Dwelling Register constitutes a dataset with a previously unseen level of detail, confidence, sample size, and research opportunities. The paper also presents an initial analysis of the dataset in terms of three heating efficiency indicators, namely 1) Annual heating energy use intensity, 2) Daily heat load variation, and 3) Cooling efficiency. The overall finding was that building typologies perform significantly different from one another concerning indicators 1 and 2, but not for indicator 3. It is therefore not possible to declare one building typology more efficient than the other as this depends on the building construction year and the considered efficiency indicator. The data indicate that further energy-efficiency improvements of the existing building stock are essential to the realization of 4th Generation District Heating technologies in Denmark and that these improvements most likely will lead to increased heat load variations that need to be addressed, for instance by enabling a larger degree of demand-side flexibility in the existing district heating systems. The large temporal variation of the buildings' cooling efficiency indicates that there is a potential for rethinking e.g. domestic hot water production in the summer or introduce differentiated billing based on the daily, weekly, or maybe seasonal cooling performance. The presented dataset can be subject to several future investigations which are also discussed in the paper. [ABSTRACT FROM AUTHOR]

The flexibility of thermal energy systems can support the energy system as a whole in integrating a large share of fluctuating renewable energy sources. The current paper investigates the flexible operation potential of a small district with buildings connected to a district heating network. In the study, the thermal mass of the buildings was utilized as heat storage and the investigation was performed for the heating season. The load shifting scenarios used were created based on the available information on heat load and dynamic heat production cost in the Greater Copenhagen district heating system. The results of the study indicate that the applied strategy of load shifting is highly effective. The achieved load shifting in all schedule-based scenarios was between 41% and 51%. The applied scenarios resulted in an increased peak demand and energy use. However, the increased energy use occurs mostly during the low-load periods, when the heat production prices are lower. It was also shown, that the increased peak can be partially mitigated by using the appropriate control strategies. [ABSTRACT FROM AUTHOR]

• The energy consumption of 38 Chinese district heating systems was investigated and compared. • Method to break down the consumption and evaluate the operational problems was presented. • Field measurements were conducted to evaluate problems leading to high energy consumption. • Overheating was responsible for 23% of total heat consumption. • Resistance, operation flow, and pump efficiency were three major problems in distribution networks. Worldwide, China has the largest district heating (DH) area and is also the fastest growing country. This paper presents field measurement results for operational energy consumption from 38 DHSs to fill in the gaps in understanding of the current operational issues of the district heating system (DHS). The average heat consumption during the heating period was 98.6 kWh/m2 and the monthly average electricity consumption for circulating pumps in the primary and secondary networks was 0.27 kWh/(m2 × month) and 0.29 kWh/(m2 × month), respectively. Thereafter, a systematic method for breaking down the energy consumption and quantitatively evaluating the underlying problems is presented. Based on several detailed measurements conducted in typical heat-exchange substations (HESs), it was found that overheating was the most prominent problem in energy-efficient buildings, constituting 23% of the total heat consumption. Another problem encountered was heat loss through pipes, which constituted approximately 5%–10% of the total heat consumption and was highly dependent on the actual conditions. In distribution networks, problems such as high resistance, high operational flow, and low pump efficiency were also identified and analyzed. Finally, practical energy-efficiency suggestions and future potential targets for the Chinese DHS are discussed from both a design and operational perspective. [ABSTRACT FROM AUTHOR]