Search

Model predictive control (MPC) has been studied in the building science realm for about three decades. However, the following two aspects of the building control have not been studied thoroughly in MPC research. One is the impact of the mixed-mode cooling system on the active heating ventilation and air conditioning (HVAC) energy consumption, and the other is the differences of individual thermal comfort preference and its impact on energy. This paper proposes an occupant-oriented mixed-mode EnergyPlus predictive control system to optimize HVAC energy consumption while meeting the individual thermal comfort preference. A web-based dashboard is implemented in the test-bed building for three months to collect individual thermal comfort preference data. The data analysis results suggest that occupants have various tolerances and preferences about thermal comfort. The simulation results show that, during one week of a typical swing season, the mixed-mode system further reduces the active HVAC energy consumption, and the diversified occupant thermal comfort preference has significant impact on HVAC energy consumption. [ABSTRACT FROM AUTHOR]

This paper quantifies green roofs energy savings which is a challenging topic, namely in Mediterranean climate with distinct heating and cooling seasons. The thermal behavior of a green roof case study in Lisbon, Portugal, was assessed through an experimental campaign during heating and cooling periods of the year of 2013. These experimental results were then used to calibrate a building energy simulation in EnergyPlus. After validation, the numerical model was used to compare the energy performance of intensive, semi-intensive and extensive green roofs. The three green roof types lead to similar heating energy needs but extensive green roof solution shows higher cooling energy needs than semi-intensive and intensive ones, of 2.8 and 5.9 times more, respectively. Furthermore, the performance of each type of green roof and different insulation properties was compared to traditional roof solutions. With no thermal insulation, extensive green roofs require 20% less energy use than black roofs and show a similar annual behavior than white roofs. Semi-intensive and intensive green roofs energy use is 60–70% and 45–60% lower than black and white roofs, respectively. Well insulated roofs do not take full advantage of evapotranspiration cooling effects, which is particularly noticeable when comparing with high reflective white roofs. [ABSTRACT FROM AUTHOR]

The paper presents the results of 1-year measurement of indoor environment parameters (temperature, relative humidity, CO 2 concentration) in exhibition rooms of one Polish museum in various periods of the year, and the results of simulation on thermal model of this building. The influence of a temperature control scheme in museum rooms on heating and cooling demand was analysed. The actual state (poor control of internal temperature) and ideal control of internal temperature were analysed – two cases in the winter and two cases in the summer. Simulations were performed by ESP-r program. The multi-zone model of the building was validated based on measurement data. Measurements and simulations revealed significant variations in the temperature in the rooms of the museum. The analysis showed that the maintaining internal temperature at constant level of 20 °C in winter reduces monthly heat demand in most of the exhibition rooms. Obtained effect is 5–16% depending on the premises. Provision the raise of a temperature by 1 K results in the increase of heat consumption by 6%. Maintenance of a desired internal temperature, which does not exceed 24 °C in the summer, requires the provision of coolness to the museum premises. [ABSTRACT FROM AUTHOR]

Abstract: The Kyoto protocol binded the developed countries to reduce the greenhouse gas emissions at least by 5% by 2008–2012 in order to tackle global warming and climate change. Some of the measures of the governments to achieve this goal are to promote new buildings construction and to retrofit existing buildings while satisfying low energy criteria. This means improving energy efficiency of buildings and energy systems, developing sustainable building concepts and promoting renewable energy sources. The design of a low energy building requires parametric studies via simulation tools in order to optimize the design of the building envelope and HVAC systems. These studies are often complex and time consuming due to a large number of parameters to consider. Hence, this paper aims to set up a methodology that simplifies parametrical studies during the design process of a low energy building. The methodology is based on the Design of Experiments (DOE) method which is a statistical method widely used in industry to perform parametric studies that reduces the required number of experiments. [Copyright &y& Elsevier]