Search

Low-cost, practicable techniques are required to limit the release of volatile organic compound-containing fumigants such as 1,3-D to the atmosphere. In this study, we aimed to quantify 1,3-D diffusion and emission from laboratory soil columns maintained under realistic conditions and thereby assess the efficacy of soil irrigation as a technique for reducing emissions. In two soils (one relatively high, and one relatively low, in organic matter), irrigation led to a limiting of upward diffusion of the fumigant and to the maintenance of higher soil gas concentrations. Therefore, rather than being emitted from the column, the 1,3-D was maintained in the soil where it was ultimately degraded. As a consequence, emission of 1,3-D from the irrigated columns was around half of that from the nonirrigated columns. It is concluded that surface irrigation represents an effective, low-cost, and readily practicable approach to lessening the environmental impact of 1,3-D fumigant use. In addition, the higher organic matter soil exhibited emissions of around one-fifth of the lower organic matter soil in both irrigated and nonirrigated treatments, due to markedly enhanced degradation of the fumigant. Organic matter amendment of soils may, therefore, also represent an extremely effective, relatively low-cost approach to reducing 1,3-D emissions. [ABSTRACT FROM AUTHOR]

Passive air samplers (polyurethane foam disks) were deployed at 23 background locations along a broadly west-east transect in 8 northern European countries and analyzed for PCBs, PBDEs, PAHs, and a range of organochlorine pesticides (HCB, DDTs, and DDEs). PCBs and PAHs were highest at the center of the transect (Denmark) and lowest in northern Norway. HCB was relatively uniformly distributed, reflecting its persistence and high degree of mixing in air. Higher DDE and DDT levels occurred in Eastern Europe and at several sites in Central Europe. PBDE levels were generally similar at all sites, but lower for some locations in Eastern Europe and Ireland. Emissions information for PCBs, HCB, and PBDEs was used as input for a multi-media chemical fate model, to generate predicted air concentrations and compare with these measured values. Different scenarios were highlighted by this exercise: (i) country and compound combinations where the national inventory gave predicted air concentrations in close agreement with those measured (e.g., PCBs in the UK); (E) country and compound combinations where predicted concentrations were well below those measured, but where advection of emissions from elsewhere is likely to be important (e.g., PCBs in Norway); (iii) consistent underestimation of compound concentrations by the emissions modeling (i.e., HCB); and (iv) general overestimation of ambient concentrations (i.e., PBDEs). Air mass trajectory analysis showed the likely role of long-range atmospheric transport (LRAT) on national levels. In general, advection from the south and west of Europe appeared to contribute to ambient POPs levels for countries in the center and northeast of the transect. Guidelines are presented as to how countries that want to assess their POPs source inventories can do so with this relatively cheap initial screening approach. [ABSTRACT FROM AUTHOR]

The article provides an overview of the mercury control technologies aimed at lessening the mercury emissions from coal-fired electric utility boilers in the U.S. The author stressed that mercury emissions from anthropogenic emission sources posed a global threat that needs to be subsided. In response, the U.S. Environmental Protection Agency proclaimed the Clean Air Mercury Rule to permanently cap and abridge emissions of mercury from coal-fired power plants. Another regulation promulgated is the Clean Air Interstate Rule, which compels further reduction of sulphur dioxide and nitrogen oxides from these power plants. Among the control technologies stressed include flue-gas desulfurization and limestone forced- oxidation.