Search

Functionalization (oxygen addition) and fragmentation (carbon loss) reactions governing secondary organic aerosol (SOA) formation from the OH oxidation of alkane precursors were studied in a flow reactor in the absence of NOx. SOA precursors were n-decane (n-C10), n-pentadecane (n-C15), n-heptadecane (n-C17), tricyclo[5.2.1.02,6]decane (JP-10), and vapors of diesel fuel and Southern Louisiana crude oil. Aerosol mass spectra were measured with a high-resolution time-of-flight aerosol mass spectrometer, from which normalized SOA yields, hydrogen-to-carbon (H/C) and oxygen-to-carbon (O/C) ratios, and CxHy+, CxHyO+, and CxHyO2+ ion abundances were extracted as a function of OH exposure. Normalized SOA yield curves exhibited an increase followed by a decrease as a function of OH exposure, with maximum yields at O/C ratios ranging from 0.29 to 0.74. The decrease in SOA yield correlates with an increase in oxygen content and decrease in carbon content, consistent with transitions from functionalization to fragmentation. For a subset of alkane precursors (n-C10, n-C15, and JP-10), maximum SOA yields were estimated to be 0.39, 0.69, and 1.1. In addition, maximum SOA yields correspond with a maximum in the CxHyO+ relative abundance. Measured correlations between OH exposure, O/C ratio, and H/C ratio may enable identification of alkane precursor contributions to ambient SOA. [ABSTRACT FROM AUTHOR]

Wildfires are important contributors to atmospheric aerosols and a large source of emissions that impact regional air quality and global climate. In this study, the regional and nearfield influences of wildfire emissions on ambient aerosol concentration and chemical properties in the Pacific Northwest region of the United States were studied using real-time measurements from a fixed ground site located in Central Oregon at the Mt. Bachelor Observatory (~2700 m a.s.l.) as well as near their sources using an aircraft. The regional characteristics of biomass burning aerosols were found to depend strongly on the modified combustion efficiency (MCE), an index of the combustion processes of a fire. Organic aerosol emissions had negative correlations with MCE, whereas the oxidation state of organic aerosol increased with MCE and plume aging. The relationships between the aerosol properties and MCE were consistent between fresh emissions (~1 h old) and emissions sampled after atmospheric transport (6-45 h), suggesting that biomass burning organic aerosol concentration and chemical properties were strongly influenced by combustion processes at the source and conserved to a significant extent during regional transport. These results suggest that MCE can be a useful metric for describing aerosol properties of wildfire emissions and their impacts on regional air quality and global climate. [ABSTRACT FROM AUTHOR]

Ethylene glycol (HOCH2CH2OH), used as engine coolant for most on-road vehicles, is an intermediate volatility organic compound (IVOC) with a high Henry's law coefficient. We present measurements of ethylene glycol (EG) vapor in the Caldecott Tunnel near San Francisco, using a proton transfer reaction mass spectrometer (PTR-MS). Ethylene glycol was detected at mass-to-charge ratio 45, usually interpreted as solely coming from acetaldehyde. EG concentrations in bore 1 of the Caldecott Tunnel, which has a 4% uphill grade, were characterized by infrequent (approximately once per day) events with concentrations exceeding 10 times the average concentration, likely from vehicles with malfunctioning engine coolant systems. Limited measurements in tunnels near Houston and Boston are not conclusive regarding the presence of EG in sampled air. Previous PTR-MS measurements in urban areas may have overestimated acetaldehyde concentrations at times due to this interference by ethylene glycol. Estimates of EG emission rates from the Caldecott Tunnel data are unrealistically high, suggesting that the Caldecott data are not representative of emissions on a national or global scale. EG emissions are potentially important because they can lead to the formation of secondary organic aerosol following oxidation in the atmospheric aqueous phase. [ABSTRACT FROM AUTHOR]

Brown carbon (BrC), which may include secondary organic aerosol (SOA), can be a significant climate-forcing agent via its optical absorption properties. However, the overall contribution of SOA to BrC remains poorly understood. Here, correlations between oxidation level and optical properties of SOA are examined. SOA was generated in a flow reactor in the absence of NOx by OH oxidation of gas-phase precursors used as surrogates for anthropogenic (naphthalene, tricyclo[5.2.1.02,6]decane), biomass burning (guaiacol), and biogenic (α-pinene) emissions. SOA chemical composition was characterized with a time-of-flight aerosol mass spectrometer. SOA mass-specific absorption cross sections (MAC) and refractive indices were calculated from real-time cavity ring-down photoacoustic spectrometry measurements at 405 and 532 nm and from UV-vis spectrometry measurements of methanol extracts of filter-collected particles (300 to 600 nm). At 405 nm, SOA MAC values and imaginary refractive indices increased with increasing oxidation level and decreased with increasing wavelength, leading to negligible absorption at 532 nm. Real refractive indices of SOA decreased with increasing oxidation level. Comparison with literature studies suggests that under typical polluted conditions the effect of NOx on SOA absorption is small. SOA may contribute significantly to atmospheric BrC, with the magnitude dependent on both precursor type and oxidation level. [ABSTRACT FROM AUTHOR]

Pollutant concentrations in the exhaust plumes of individual diesel trucks were measured at high time resolution in a highway tunnel in Oakland, CA, during July 2010. Emission factors for individual trucks were calculated using a carbon balance method, in which pollutants measured in each exhaust plume were normalized to measured concentrations of carbon dioxide. Pollutants considered here include nitric oxide, nitrogen dioxide (NO2), carbon monoxide, formaldehyde, ethene, and black carbon (BC), as well as optical properties of emitted particles. Fleet-average emission factors for oxides of nitrogen (NOx) and BC respectively decreased 30 ± 6 and 37 ± 10% relative to levels measured at the same location in 2006, whereas a 34 ± 18% increase in the average NO2 emission factor was observed. Emissions distributions for all species were skewed with a small fraction of trucks contributing disproportionately to total emissions. For example, the dirtiest 10% of trucks emitted half of total NO2 and BC emissions. Emission rates for NO2 were found to be anticorrelated with all other species considered here, likely due to the use of catalyzed diesel particle filters to help control exhaust emissions. Absorption and scattering cross-section emission factors were used to calculate the aerosol single scattering albedo (SSA, at 532 nm) for individual truck exhaust plumes, which averaged 0.14 ± 0.03. [ABSTRACT FROM AUTHOR]

Atmospheric emissions of gas and particulate matter from a large ocean-going container vessel were sampled as it slowed and switched from high-sulfur to low-sulfur fuel as it transited into regulated coastal waters of California. Reduction in emission factors (EFs) of sulfur dioxide (SO2), particulate matter, particulate sulfate and cloud condensation nuclei were substantial (≥90%). EFs for particulate organic matter decreased by 70%. Black carbon (BC) EFs were reduced by 41%. When the measured emission reductions, brought about by compliance with the California fuel quality regulation and participation in the vessel speed reduction (VSR) program, are placed in a broader context, warming from reductions in the indirect effect of SO4 would dominate any radiative changes due to the emissions changes. Within regulated waters absolute emission reductions exceed 88% for almost all measured gas and particle phase species. The analysis presented provides direct estimations of the emissions reductions that can be realized by California fuel quality regulation and VSR program, in addition to providing new information relevant to potential health and climate impact of reduced fuel sulfur content, fuel quality and vessel speed reductions. [ABSTRACT FROM AUTHOR]

A recently developed method to rapidly quantify the elemental composition of bulk organic aerosols (OA) using a high-resolution time-of-flight aerosol mass spectrometer (HR-ToF-AMS) is improved and applied to ambient measurements. Atomic oxygen-to-carbon (O/C) ratios characterize the oxidation state of OA, and O/C from ambient urban OA ranges from 0.2 to 0.8 with a diurnal cycle that decreases with primary emissions and increases because of photochemical processing and secondary OA (SOA) production. Regional O/C approaches 0.9. The hydrogen-to-carbon (H/C, 1.4-1.9) urban diurnal profile increases with primary OA (POA) as does the nitrogen-to-carbon (N/C, ∼0.02). Ambient organic-mass-to-organic-carbon ratios (OM/OC) are directly quantified and correlate well with O/C (R² = 0.997) for ambient OA because of low N/C. Ambient O/C and OM/OC have values consistent with those recently reported from other techniques. Positive matrix factorization applied to ambient OA identifies factors with distinct O/C and OM/OC trends. The highest O/C and OM/OC (1.0 and 2.5, respectively) are observed for aged ambient oxygenated OA, significantly exceeding values for traditional chamber SOA, while laboratory-produced primary biomass burning OA (BBOA) is similar to ambient BBOA, O/C of 0.3-0.4. Hydrocarbon-like OA (HOA), a surrogate for urban combustion POA, has the lowest O/C (0.06-0.10), similar to vehicle exhaust An approximation for predicting O/C from unit mass resolution data is also presented. [ABSTRACT FROM AUTHOR]

The emissions from in-use commercial aircraft engines have been analyzed for selected gas-phase species and particulate characteristics using continuous extractive sampling 1-2 mm downwind from operational taxi- and runways at Hartsfield- Jackson Atlanta international Airport. Using the aircraft tail numbers, 376 plumes were associated with specific engine models. In general, for takeoff plumes, the measured NO~ emission index is lower (`--~18%) than that predicted by engine certification data corrected for ambient conditions. These results are an in-service observation of the practice of "reduced thrust takeoff". The CO emission index observed in ground idle plumes was greater (up to 100%) than predicted by engine certification data for the 7% thrust condition. Significant differences are observed in the emissions of black carbon and particle number among different engine models/technologies. The presence of a mode at ~-~65 nm (mobility diameter) associated with takeoff plumes and a smaller mode at `~25 nm associated with idle plumes has been observed. An anticorrelation between particle mass loading and particle number concentration is observed. [ABSTRACT FROM AUTHOR]