Search

Ethanol plays a crucial role in modern industrial processes and consumer products. Despite its presence in human activity, short and long-term exposure to gaseous ethanol poses risks to health conditions and material damage, making the control of its concentration in the atmosphere of high importance. Ethanol optical sensors based on electromagnetic surface waves (ESWs) are presented, with sensitivity to ethanol vapours being achieved by the inclusion of ethanol-adsorptive zinc oxide (ZnO) layers. The changes in optical properties modulate the resonant conditions of ESWs, enabling the tracking of ethanol concentration in the atmosphere. A comprehensive comparative study of sensor performance is carried out between surface plasmon resonance (SPR) and Bloch surface wave (BSW) based sensors. Sensor efficiency is simulated by transfer matrix method towards optimized figures of merit (FoM). Preliminary results validate ethanol sensitivity of BSW based sensor, showcasing a possible alternative to electromagnetic and plasmonic sensors.

Structural health monitoring (SHM) of reinforced concrete structures (RCS) is crucial for mitigating the consequences of their deterioration. By identifying and addressing the issues early, SHM helps reduce environmental impact, safeguard lives, and enhance economic resilience. Rebar corrosion is a leading cause of early RCS decay and optical fibre sensors (OFS) have been employed for its monitoring. Reflection optrodes using optical fibres where the tip is coated with iron (Fe) thin films offer a robust, longlasting and straightforward solution. This study investigates the tracking of spectral changes during the Fe thin film corrosion, which has been neglected in the literature, in favour of tracking reflection changes from thin film spalling. A multimode fibre tip, coated with a thin Fe layer embedded in concrete, allows spectral changes to be observed during corrosion. A 100 nm thick Fe film was deposited using radio frequency magnetron sputtering on polished fibre tips. Corrosion was induced by applying salted water drops and allowing the fibre tip to dry. Corrosion monitoring was successful for both air-exposed and cementembedded tips, with results compared to reflection simulations of Fe, Fe2O3, and Fe3O4 thin films. This study supports monitoring at different wavelengths, enhancing robustness, cost-effectiveness and earlier detection.

Due to the exponential increase in energy consumption and CO2 emissions, new sustainable energy sources have emerged, and hydrogen (H2) is one of them. Despite all the advantages, H2 has high flammability, so constant monitoring is essential. Two optical techniques were numerically studied and compared with the goal of H2 sensing: surface plasmon polaritons (SPP) and Tamm plasmon polaritons (TPP). The H2-sensitive material used was palladium (Pd) in both techniques. The SPP structure was found to have more sensitivity to H2 than TPP, 23 and 5nm/4vol% H2, respectively. However, the latter has lower FWHM, with the minimum of the band showing reflectivity near 0%. In addition, TPP also uses more costeffective materials and can be interrogated at normal incidence with depolarized light. The potential of using each of these optical techniques for H2 sensing was demonstrated.