Search

Objective: The aim of the study was to investigate the physicochemical stability of mitomycin-containing medicinal products for bladder instillation, formulated with urea as excipient (mito-medac®, Mitomycin medac). For comparison, the stability of reconstituted Urocin® and Mitem® bladder instillation was studied., Methods: Mitomycin-containing medicinal products were either reconstituted with the prepackaged 0.9% NaCl solution, nominal volume 20 mL (mito-medac®, Mitem®, Urocin®) or with 20 mL water for injection (Mitomycin medac, Mitem®, Urocin®) to a nominal concentration of 1 mg/mL and stored at room temperature (20-25°C). Samples were taken immediately after reconstitution and after 24 hours. Physicochemical stability was determined by reverse-phase high performance liquid chromatography with photodiode array detection, measurement of pH and osmolarity, and inspection for visible particles or colour changes., Results: The initial pH values of the test solutions reconstituted with prepackaged 0.9% NaCl (5.2-5.6) were significantly lower than those reconstituted with water for injection (6.6-7.4). Solutions reconstituted with 0.9% NaCl solutions rapidly degraded and concentrations fell below the 90% limit after 24 hours of storage. When reconstituted with water for injection, degradation was less rapid. Concentrations of Mitomycin medac and Urocin remained above the 90% limit after 24 hours., Conclusions: The physicochemical stability of mitomycin 1 mg/mL bladder instillation prepared with prepackaged 0.9% NaCl in prefilled PVC bags is less than 24 hours at room temperature. Unfavourable pH values of the solvents cause rapid degradation of mitomycin. Mitomycin solutions reconstituted at the point of care should be administered immediately to avoid degradation and loss of efficacy. Urea added as excipient did not accelerate degradation., Competing Interests: Competing interests: None declared., (© European Association of Hospital Pharmacists 2024. No commercial re-use. See rights and permissions. Published by BMJ.)

Objectives: To investigate the effect of pH and buffers on the degradation rate of flucloxacillin and to determine if flucloxacillin can be stabilised using a buffered diluent for up to 14 days when stored at 2°C-8°C including a 24-hour infusion period at 32°C in two elastomeric devices (Accufuser and INfusor LV) filled to 240 mL. Testing as per the NHS Pharmaceutical Quality Assurance Committee Yellow Cover Document (YCD) requirements., Methods: A validated stability indicating high-performance liquid chromatography method was used for assessing the stability of flucloxacillin diluted in 0.3% w/v citrate-buffered saline pH 7.0 when stored at 2°C-8°C in two ambulatory devices (Accufuser and INfusor LV). Flucloxacillin at 10 and 50 mg/mL diluted in 0.3% w/v citrate-buffered saline pH 7.0 to a final volume of 240 mL and stored at 2°C-8°C, including 24 hours at 32°C, was tested from two batches in replicate (n=3) at five time points for up to 14 days according to the requirements of the YCD., Results: Greater than 95% of the zero-time concentration of flucloxacillin at 10 and 50 mg/mL remained when stored at 2°C-8°C after 14 days including 24 hours at 32°C in both Accufuser and INfusor LV devices., Conclusions: Flucloxacillin sodium stability was improved, and complied with UK national standards, by using a diluent of 0.3% w/v citrate-buffered saline pH 7 in both Accufuser and INfusor LV ambulatory devices when filled to 240 mL. The data support assigning a shelf-life of up to 14 days (13 days stored at 2°C-8°C and 24 hours at 32°C). Flucloxacillin may now be used appropriately as a continuous 24-hour infusion in outpatient parenteral antimicrobial therapy services, providing further opportunity to avoid or shorten patient hospital stays, as well as support ideal antimicrobial stewardship principles., Competing Interests: Competing interests: None declared., (© European Association of Hospital Pharmacists 2020. Re-use permitted under CC BY-NC. No commercial re-use. Published by BMJ.)

Background and Objective: Infusion containing paracetamol, alizapride, ketorolac and tramadol is used after a general anaesthesia in order to limit pain, fever and nausea. Currently, these infusions are prepared according to demand in the anaesthesia unit, but the preparation in advance could improve quality of preparation and time management. The aim of this study was to investigate the long-term stability of this infusion in glass bottles at 5°C ± 3 °C., Method: Five bottles of infusion were stored at 5°C ± 3 °C for 60 days. A visual and microscope inspection were performed periodically to observe any particle appearance or colour change. pH and absorbance at three wavelengths were measured. The concentrations were measured by ultra-high performance liquid chromatography - diode array detection., Results: Multiple verifications were performed during the first 35 days and no crystal, impurity or colour change were observed. At the next time point (42nd day), crystals were visible to the naked eye. pH and absorbance at 350 nm and 550 nm were stable. A slight increase in the absorbance at 410 nm was observed during the study, suggesting that a degradation product could be formed and absorb at this wavelength. The infusion was considered chemically stable while the lower one-sided prediction limit at 95% remains superior to 90% of the initial concentration. Concentration measurements demonstrated that ketorolac and alizapride remained stable in the infusion for 35 days. The stability of tramadol was 28 days. However, degradation of paracetamol was much faster given that concentration has fallen below 90% of the initial concentration after 7 days., Conclusion: Infusion of paracetamol, alizapride, ketorolac and tramadol remains stable for 7 days in glass bottles at 5°C ± 3 °C and could be prepared in advance with these storage conditions., Competing Interests: Competing interests: None declared., (© European Association of Hospital Pharmacists 2020. No commercial re-use. See rights and permissions. Published by BMJ.)

Objectives: Norepinephrine is a vasopressor frequently administered after dilution to treat hypotension and shocks in intensive care units. The stability of norepinephrine is known to be highly sensitive to storage conditions. Moreover, medication errors linked to the dilution step are frequent and may be deleterious for critically-ill patients, especially in intensive care units. This study aimed to evaluate the stability of ready-to-use diluted norepinephrine solutions prepared at two target concentrations (0.2 and 0.5 mg/mL), according to the summary of product characteristics, and stored for 365 days in two containers: AT-closed cyclic olefin copolymer vials, and polypropylene syringes., Methods: A fast reversed-phase liquid chromatography method coupled with an ultra-violet detector was developed to assess the chemical stability of norepinephrine solutions. Validation was conducted according to the linearity of the calibration ranges, selectivity, sensitivity, accuracy and precision. Dosage, sub-visible particle contamination, pH monitoring and sterility assays were performed. Chemical stability was maintained if the measured concentration respected the lower limit of 90% of the initial concentration. Containers were stored at -20±5°C, +5±3°C and +25±2°C with 60±5% relative humidity in a dark closed enclosure., Results: Stability was successfully maintained for every concentration and container tested when stored at -20±5°C and +5±3°C. In these storage conditions, particle contamination, pH monitoring and sterility assay respected the required criteria. Chemical degradation and colouring of solutions appeared before the end of the 1 year study period for most norepinephrine solutions stored at room temperature., Conclusions: Ready-to-use solutions containing 0.2 and 0.5 mg/mL norepinephrine in polypropylene syringes or cyclic olefin copolymer vials must be stored at refrigerated or frozen temperatures to obtain acceptable 1 year shelf-stability. Exposure to higher temperatures significantly decreases shelf-stability. Our study protocol for compounding polypropylene syringes and cyclic olefin copolymer vials containing norepinephrine is adapted to implementation in centralised intravenous additive services., Competing Interests: Competing interests: None declared., (© European Association of Hospital Pharmacists 2020. No commercial re-use. See rights and permissions. Published by BMJ.)

Introduction: According to the manufacturers, the diluted solution of etoposide should not exceed 0.4 mg/mL because precipitation may occur. For high doses or for patients requiring fluid restrictions, etoposide phosphate may be an option but shortages occurs frequently. The objective of this work was to study the stability of etoposide solutions between 0.38 and 1.75 mg/mL, diluted in 0.9% sodium chloride (0.9% NaCl) or 5% glucose (G5%) in polyolefin bags, stored at 25°C and between 2°C to 8°C, in a 61-day period. This study also observed the impact of an infusion pump on the physical and chemical stability of etoposide solutions., Materials and Method: Chemical stability was analysed at days 0, 9, 16, 21, 28 and 61 by high-performance liquid chromatography. Physical stability was evaluated by visual and subvisual inspection. The action of an infusion pump on solutions was evaluated to verify the impact of the mechanical pumping action on the etoposide solutions. This investigation was performed at day 61, at the end of the study., Results: Etoposide solutions diluted at 0.38, 0.74 and 1.26 mg/mL in G5% and stored at 25°C were stable for 61 days and at 1.75 mg/mL for 28 days. In 0.9% NaCl, etoposide was less stable, with more precipitations observed. The action of an infusion pump has not caused any physical modifications., Conclusion: Storage at 25°C and G5% as diluent are recommended for etoposide high concentration with 61-day stability up to a concentration of 1.26 mg/mL and 28-day stability up to a concentration of 1.75 mg/mL. As a precaution, the use of an administration set with an in-line micro-filter is nevertheless recommended. Storage at 2°C to 8°C and the use of 0.9% NaCl increase the risk of precipitation., Competing Interests: Competing interests: None declared., (© European Association of Hospital Pharmacists 2020. No commercial re-use. See rights and permissions. Published by BMJ.)