Search

The enhanced X-ray Timing and Polarimetry mission (eXTP) is a next-generation flagship X-ray astronomy satellite currently in phase-B study. The large Area Detector (LAD) on board eXTP contains 40 modules, each consisting of a set of 4 × 4 large area SDDs and 4 × 4 collimators, and has a designed effective area of 3.0 m 2 at 8 keV and a Field of View (FoV) of 1 ∘ . To achieve such a large effective area, the collimator’s Open Area Ratio (OAR) should be greater than 70%. In this paper, we introduce the measurement methods used to determine the OAR and the rocking curve (angular response) of the LAD collimator at the 100-m X-ray Test Facility (100XF) of the Institute of High Energy Physics (IHEP) in Beijing, and report the results of the collimators manufactured under different conditions. The measured OARs of the collimators are usually smaller than the theoretical values by a few percent, which is due to the non-uniformity and irregularity of the pores. The measured rocking curves are usually broader than the theoretical triangular curves, and the lower the energy of the incident X-ray the broader the rocking curve. This broadening of the rocking curve is the result of reflection on the inner wall of the pores. Our results also show that increasing the etching time in the manufacturing of the collimators can increase the OARs but does not change significantly the shape of the rocking curves. [ABSTRACT FROM AUTHOR]

The spectroscopy focusing array is one of the four main scientific instruments of the enhanced X-ray Timing and Polarimetry mission, tasked with spectral and timing observation in the energy range 0.5-10 keV. An engineering model of the spectroscopy focusing array with a 4 mirror shells assembly and a focal plane detector using commercial detectors has now been developed. To evaluate the performance, the spectral and timing calibration of the engineering model has been held in the 100-m X-ray Test Facility. A multi-target X-ray source with multiple emission lines is used to calibrate the spectral performance. A timing X-ray source based on a grid controlled X-ray tube has been utilized for the timing calibration. The timing X-ray source can generate X-ray pulses to measure the response time distribution, and can also simulate the pulsar lightcurves to examine the detection ability for pulsars. The energy-channel relation and energy resolution are determined through spectral calibration. The energy resolution at 5.95 keV is 142 eV, now. According to the timing calibration, the mean response time of the engineering model is 1.55 μ s, the full width at half maximum of the response time distribution is 0.45 μ s, and the engineering model has sufficient ability to detect the profile of millisecond pulsars. [ABSTRACT FROM AUTHOR]

The 100-m X-ray Test Facility of the Institute of High Energy Physics (IHEP) was initially proposed in 2012 for the test and calibration of the X-ray detectors of the Hard X-ray Modulation Telescope (HXMT) with the capability to support future X-ray missions. The large instrument chamber connected with a long vacuum tube can accommodate the X-ray mirror, focal plane detector and other instruments. The X-ray sources are installed at the other end of the vacuum tube with a distance of 105 m, which can provide an almost parallel X-ray beam covering 0.2 ∼ 60 keV energy band. The X-ray mirror modules of the Einstein Probe (EP) and the enhanced X-ray Timing and Polarimetry mission (eXTP) and payload of the Gravitational wave high-energy Electromagnetic Counterpart All-sky Monitor (GECAM) have been tested and calibrated with this facility. It has been also used to characterize the focal plane camera and aluminum filter used on the Einstein Probe. In this paper, we will introduce the overall configuration and capability of the facility, and give a brief introduction of some calibration results performed with this facility. [ABSTRACT FROM AUTHOR]