Search

Biodegradation is a key process for the remediation of sites contaminated by petroleum hydrocarbons (PHCs), but this process is not well known for the (semi)-arid coastal environments where saline conditions and continuous water level fluctuations are common. This study differs from the limited previous studies on the biodegradation of PHCs in Qatari coastal soils mainly by its findings on the biodegradation kinetics of the selected PHCs of benzene and naphthalene by indigenous bacteria. Soil samples were collected above, across, and below the groundwater table at the eastern coast of Qatar within a depth of 0 to -40 cm. Environmental conditions combining low oxygen and high sulfate concentrations were considered in this study which could favor either or both aerobic and anaerobic bacteria including sulfate-reducing bacteria (SRB). The consideration of SRB was motivated by previously reported high sulfate concentrations in Qatari soil and groundwater. Low- and high-salinity conditions were applied in the experiments, and the results showed the sorption of the two PHCs on the soil samples. Sorption was dominant for naphthalene whereas the biodegradation process contributed the most for the removal of benzene from water. Losses of nitrate observed in the biodegradation experiments were attributed to the activity of nitrate-reducing bacteria (NRB). The results suggested that aerobic, NRB, and most likely SRB biodegraded the two PHCs, where the combined contribution of sorption and biodegradation in biotic microcosms led to considerable concentration losses of the two PHCs in the aqueous phase (31 to 58% after 21 to 35 days). Although benzene was degraded faster than naphthalene, the biodegradation of these two PHCs was in general very slow with rate coefficients in the order of 10-3 to 10-2 day-1 and the applied kinetic models fitted the experimental results very well. It is relevant to mention that these rate coefficients are the contribution from all the microbial groups in the soil and not from just one.

The migration of fine particles in porous media has been studied for different applications, including gas production from hydrate-bearing sediments. The clogging behavior of fine particles is affected by fine particle-pore throat size ratio, fine particle concentration, ionic concentration of fluids, and single/multiphase fluid flow. While previous studies presented valuable results, the data are not enough to cover a broad range of particle types and sizes and pore throat size in natural hydrate-bearing sediments. This paper presents a novel micromodel to investigate the effects of fine particle-pore throat size ratio, fine concentration, ionic concentration of fluid, and single/multiphase fluid flow on clogging or bridging in porous media. The results show that (1) the concentration of fine particles required to form clogging and/or bridging in pores decreased with the decrease in fine particle-pore throat size ratio, (2) the effects of ionic concentration of fluid on clogging behaviors depend on the types of fine particles, and (3) fine particles prefer to accumulate along the deionized water- (DW-) CO2 interface and migrate together, which in turn easily causes clogging in pores. As a result, multiphase fluid flow during gas production from hydrate-bearing sediments could easily develop clogging in pore throats, where the relative permeability of DW-CO2 in porous media decreases. Accordingly, the relatively permeability of porous media should be evaluated by considering the clogging behavior of fines.