Search

This paper describes an improved concept for the mapping of tropical forest classes with ALOS AVNIR and ALOS PALSAR data. The improvement comes from a combination of a sample of very high resolution (VHR) satellite images with medium resolution wall-to-wall mapping in a statistical sampling framework. The approach developed makes it possible to obtain reliable information on mapping accuracy over the whole area of interest. A simulation study indicated that the sample of VHR images should be collected in a stratified manner using small (25 km) images. The VHR images should cover approximately one percent of the total area of interest, depending on the accuracy requirement. The recommended size of the reference plots (population units) that are selected within the VHR imagery is in the order of 50 m by 50 m. In a systematic selection the plots should be located at a distance of several hundred meters from each other. The forest variables were predicted with an unsupervised fuzzy classification method. The ALOS AVNIR-based forest/non-forest mapping accuracies varied between 68% and 97% of the areas of the VHR images. The corresponding ALOS PALSAR mapping accuracies were poorer. At AVNIR resolution, the area of natural forest was over-estimated, and the degree of disturbance underestimated in humid, heavily disturbed parts of the study area in Laos. The three predictions for the total forest fraction from VHR, AVNIR and PALSAR data over the area that was covered by the VHR images were 55.1%, 53.6%, and 52.8%, respectively.

This paper presents a modified robust stem volume retrieval approach suitable for use with L-band SAR imagery. Multitemporal dual-polarization SAR imagery acquired by ALOS PALSAR during the summer-autumn 2007 is used in the study, along with stand-wise forest inventory data from two boreal forest sites situated in central Finland. The average sizes of forest stands at the study sites were 3 ha and 4.8 ha. The method used employs model fitting with an inverted semi-empirical boreal forest model, and takes advantage of the multitemporal aspect in order to improve the stability and accuracy of stem volume estimation. Multitemporal combination of model output in a multivariate regression framework allows volume estimates to be obtained with an RMSE about 43% of the mean of 110 m3/ha, and a coefficient of determination R2of 0.71 in the best case. The methodology used can be employed to produce large-area stem volume maps from dual-polarization ALOS PALSAR imagery mosaics.

Performance of the above ground (dry) biomass estimation with the medium resolution optical (ALOS AVNIR) data and radar (ALOS PALSAR) data was evaluated on a tropical forest site in Lao PDR (Laos). The average biomass of ground reference plots was relatively low, 78 t/ha, due to strong anthropogenic influence in most of the study area. The biomass estimates were computed using linear regression analysis and the Probability method that combines unsupervised clustering and fuzzy estimation. The predictions were validated with independent field plot data. With all the methods and data types, the root mean square error (RMSE) ranged from 33.6 t/ha to 40.1 t/ha (44.2% and 52.8% of mean biomass, respectively). The Probability method produced a larger dynamic range to the predictions than the regression models, which saturated at approximately 100 t/ha. Large errors for higher biomass plots increased the RMSE of Probability over the RMSE of the regression models. The bias ranged from -0.8 to 3.9% except with the Probability model for PALSAR data where the bias was 12.5%. Our study showed that PALSAR data were nearly as good for the biomass estimation as the AVNIR data. A combination of mono-temporal ALOS PALSAR and ALOS AVNIR data did not improve biomass estimation over the performance obtained with AVNIR data alone. For the Probability method, ground reference data should be more representative than that available in this study.