Search

A low-profile wideband tri-polarized MIMO antenna is proposed in this paper. Based on characteristic mode analysis of a circular patch, four slots are etched symmetrically on the patch to transform the high-order monopole-like modes into broadside modes with lower resonant frequencies. Four sets of shorting pins are also applied to simultaneously adjust the resonant frequencies of the monopole-like modes and broadside fundamental modes of the patch. The effects of the slots and the shorting pins on these modes are analyzed in detail. Three dual-resonance ports with high isolation are achieved by exciting three pairs of orthogonal modes of the patch. The proposed antenna is wideband with respect to its profile (bandwidth/height = 216), as facilitated by the dual-resonance property of each port. Experimental results show that the proposed antenna features high port isolation (> 35 dB) and high gain (> 5.58 dB). The proposed low-profile wideband tri-port antenna can be applied in highly integrated MIMO systems.

In this communication, a novel planar structure-shared diverse two-port ultrawideband (UWB) antenna with high isolation and common ground is proposed based on a new slot-loaded method. A tapered slot with an end-fire radiation pattern is etched in the top middle section of a coplanar waveguide (CPW)-fed printed monopole antenna to reduce its effects on the monopole mode. The two-port UWB antenna features diverse patterns which can fully cover the upper space. A nonuniformly symmetric-coupled coplanar waveguide (NSC-CPW) is introduced to enable the two sets of the feeding structures sharing a ground plane with minimum interaction. Due to the modal orthogonality, high isolation between the two ports is obtained without additional decoupling structures. The experimental results of the proposed multiple-input multiple-output (MIMO) antenna indicate that the isolation is higher than 31.4 dB and the diversity gain is approximately 10 dB within a wide frequency range from 2.98 to 10 GHz. Meanwhile, high realized peak gain (>2.5 dB) and good efficiency (>80%) are also obtained for both the ports.

A two-port structure-shared planar ultrawideband (UWB) antenna with high isolation is presented in this communication. The proposed antenna consists of a planar monopole and two back-to-back tapered slots etched on the monopole. The monopole and the tapered slots are fed by the microstrip line and the differential feeding network, respectively. The differential feeding network of the tapered slots excites the modes, which are orthogonal to those of the monopole. Therefore, high isolation between the two ports can be achieved without additional decoupling structures. The measured results show that the proposed antenna can operate from 3 to 10 GHz with the reflection coefficient of the two ports lower than −10 dB and the isolation higher than 38 dB. The measured realized peak gains are above 2.6 dB, and the measured envelope correlation coefficients are less than $9 \times 10^{-5}$ . The proposed UWB multiple-input-multiple-output (MIMO) antenna can be applied in the MIMO communication systems, especially those requiring high isolation.

This paper presents a low-profile coplanar dual-polarized dual-band base station antenna array. A slotted patch antenna operating from 0.82 to 0.99 GHz with four shorting strips is proposed and analyzed. The four shorting strips are employed not only to improve the impedance matching in the lower band but also to remove the center part of the patch, thus making room for higher band dipoles operating from 1.68 to 2.86 GHz. The height of the proposed array is nearly half of the conventional base station array while other performances are guaranteed. The measured results show that the proposed antenna array has wide impedance bandwidths of 18.7% (0.82–0.99 GHz) and 57.9% (1.68–2.86 GHz) (VSWR $0.109\lambda _{0}$ at 820 MHz). The measured gains are 13.8±0.5 dB and 16.7 ± 1 dB in lower and upper bands. Large front-to-back ratio (>24.6 dB) and high isolations (>30 and >25 dB in lower and upper bands, respectively) are achieved. The proposed antenna can be easily built with printed circuit board fabrication technique and applied in low profile multiband base stations for 2G/3G/4G and the next-generation systems.