Search

This paper presents a novel control technique for a wide output voltage range digitally controlled SIDO boost converter. It employs minimum phase conditions reported in refid="ref1"/ , refid="ref2"/ and extends the same to SIDO boost converter to eliminate the effect of RHP zero. Further, the proposed work employs input-output linearization technique refid="ref3"/, refid="ref4"/ to linearize the control-to-output transfer function across different operating points to achieve improved stability under unbalanced loads and a wide output voltage range on each output of the proposed SIDO boost power converter. The SIDO boost regulator was verified experimentally for an input voltage of 3.3 V and a maximum simultaneous load current of 350 mA on each output. Measurement results demonstrate that the proposed design achieves a wide output voltage range of 4.8 V–13.75 V, with ability to dynamically transition across these different output voltages in both small and big voltage steps. [ABSTRACT FROM AUTHOR]

In this paper the stability and sensitivity function of three basic dc-dc converter with the consideration of circuit parasitics has been analyzed for analog and digital controller implementation. The steady state and small-signal analysis has been used to derive the mathematical expressions for uniformly sampled voltage-mode controlled converters. The effect of digital controller using the ratio of sampling to carrier frequency has been analyzed. The sampling frequency limits the voltage gain in the stepped manner and also affects the stability of the digitally controlled converter. The sensitivity function has been defined for voltage gain with respect to various system parameters. The maximum affected regions on duty ratio scale with corresponding parasitic variable have been discussed. The detailed stability analysis has been carried out for digitally implemented three basic dc-dc converters, i.e., buck, boost, and buck-boost circuits. The analytical results are verified with the simulations performed in PSCAD/EMTDC. An FPGA controller is considered as digital controller for the dc-dc converter and verification of the results through experiment. [ABSTRACT FROM PUBLISHER]

Active pulse-width-modulated (PWM) voltage rectifiers are commonly used to convert ac power from a three-phase grid to a regulated dc voltage with unity input power factor. The output voltage regulation is normally achieved by an outer voltage feedback loop and a sinusoidal pulse-width-modulated (SPWM) inner current loop. Due to output voltage disturbances, such as those produced by a capacitive load, the inner current loop can be easily driven into over-modulation and possible six-step operating regions. Current research efforts have focused on extending the linearity of the modulated voltage in the over-modulation range to reduce the input current harmonics and on studying the closed-loop stability via conventional small-signal linearization around a fixed operating point. Such linear techniques obviously fall short of predicting large-signal transient stability. In this paper, catastrophic bifurcation of the three-phase voltage-source converter is reported. The physical origin of the phenomenon is identified. Boundaries of catastrophic bifurcation in the parameter space are derived. The phenomenon has been verified experimentally. [ABSTRACT FROM PUBLISHER]

A floating buck controlled multi-mode dimmable light-emitting diode (LED) driver that uses a stacked NMOS switch is presented, which reduces static operational current and eliminates auxiliary winding to simplify design and cost. The accuracy of the output current benefits from the use of a line-voltage compensation technique which can mitigate the effect of line-voltage fluctuation on current consistency. The proposed LED driver is implemented in 0.5 \mum 5V/40 V backend 2P2M CMOS process and occupies a die size (with pads) of 1.17\times 0.84\ mm^2. The experimental results show that the proposed LED driver achieves peak power efficiency of 95.4% across a wide range of input voltage from 85 to 264 Vac and a wide range of series-connected load LEDs from 11 to 27. The worst-case line regulation and load regulation of the output current are 0.28% and 0.25%, respectively. Measurements further show that the startup time is only 34.8 ms at 220 Vac with 50 Hz-input and multi-mode dimming can be easily implemented. [ABSTRACT FROM AUTHOR]