Search

This paper reports a novel systematic theory of the noise invariants of two-port linear noisy networks under lossless reciprocal input and output impedance transformations. The theory clarifies the relationship between the circuit theory of linear noisy networks and the theory of four noise parameters, which are widely applied in the design of low-noise amplifiers (LNAs). In particular, we prove that the fundamental noise invariants under input and output impedance transformations are the eigenvalues of a permuted version of the noise correlation matrix and that there is no feedback operation that preserves them. Known invariants, such as the minimum equivalent noise temperature ${T}_{{N}{min}}$ and ${N}$ , may be expressed in terms of such eigenvalues. In addition, we provide a complete characterization of the four noise parameters of two-port passive dissipative networks in terms of their gain parameters and derive the condition under which the invariant ${4N}{T}_{{0}}{/}{T}_{{N}{min}}$ of passive nonreciprocal networks is lower than two. We also extend the theory of special noise invariants to LNAs with lossy input matching network. Overall, the impact of the findings emerging from the theory is highlighted through theorems, remarks, circuit examples, and studies on widespread design methodologies. [ABSTRACT FROM AUTHOR]

The transformer-based input integrated matching allows the realization of the simultaneous optimum noise and maximum power transfer input impedance matching in cascode amplifiers by exploiting the mutual coupling between the two spirals of an integrated transformer. This technique has been adopted to design LNAs operating in the microwave and millimeter-wave frequency ranges; however, the analytical proofs are still missing. This paper addresses for the first time a complete and in-depth study of the circuit topology and design technique in order to provide the analytical proofs. In-depth analyses are also used to get useful circuit insights, derive effective design equations, and carry out a direct comparison with the most widespread cascode low-noise amplifier with inductive degeneration through circuit design under the same conditions. [ABSTRACT FROM PUBLISHER]

System-on-chip (SoC) miniaturization of radiometric sensors could dramatically improve quantitatively the study of Earth’s atmosphere in the microwave- and millimeter-wave frequency regions, enabling cost and weight reductions both for ground- and space-based observation instruments. This paper reports the analysis, design, implementation, and experimental characterization of the first K-band SoC Dicke radiometric receiver implemented in a commercial silicon–germanium technology under Space evaluations. The radiometric receiver exhibits a responsivity of about 760 kV/W and a noise equivalent power of about 232 fW/ $\surd $ Hz at the center frequency of 25.75 GHz. For a bandwidth of 2.5 GHz, the system achieves a resolution of 9 K for a relatively short integration time (1 s), 2.8 K for a medium integration time (10 s), and 0.9 K for a relatively long integration time (100 s). [ABSTRACT FROM AUTHOR]

A low-complexity fully integrated ultrawideband (UWB) monocycle pulse generator realized in 90-nm CMOS technology by ST-Microelectronics is presented. The circuit provides a monocycle pulse when activated by a negative edge of an external trigger signal provided by a microcontroller by exploiting the operating principle of nonlinear waveform shapers. This pulse generator represents a building block of an innovative wearable system-on-chip UWB radar on silicon for cardiopulmonary monitoring. On-chip measurements show that the pulse generator provides monocycle pulses with a duration time equal to 380 ps and a peak-to-peak amplitude of 660 mV (including the losses of the microprobes, cables, and electrostatic-discharge-protected pads), which are in very good agreement with the postlayout simulations. The power consumption is 19.8 mW from a 1.2-V power supply. [ABSTRACT FROM PUBLISHER]

Welcome to the 2017 Special Issue on the IEEE Circuits and Systems Society (CASS) Regional Flagship Conferences, a collection of selected papers presented at the 2016 IEEE Asia Pacific Conference on Circuits and Systems (APCCAS 2016), held in Jeju, South Korea, October 25–28, 2016, the 23rd IEEE International Conference on Electronics Circuits and Systems (ICECS 2016), held in Monte Carlo, Monaco, December 11–14, 2016, and the 8th IEEE Latin American Symposium on Circuits and Systems (LASCAS 2017), held in Bariloche, Argentina, February 20–23, 2017. In APCCAS 2016, 212 papers were presented, selected from 310 papers submitted; in ICECS 2016, 191 papers were presented, selected from 353 papers submitted; in LASCAS 2017, 70 papers were presented, selected from 172 papers submitted. [ABSTRACT FROM AUTHOR]