Search

In this paper, we propose and design a novel generator for the high voltage square pulses with the changeable polarities in order to reach the requirements and the needs for the intended experiments on sterilization of microorganism. The major component of our circuits is a non-trivial combination between a half bridge Marx generator and an H bridge in series, combining with the DSP control unit, which can adjust the voltages, frequencies, pulse widths and polarities, and also tolerate various loads. More precisely, we illustrate the design and operation principles for each module in the constructed circuit and analyze the system performance with various loads. The effectiveness and correctness of our proposed circuit and methodologies have been verified and demonstrated by both PSIM simulation results and our own prototype. In this paper, we also show the stability and reliability of the pulse generator we proposed in terms of various load conditions and operation safety respectively. Furthermore, we also observe that the key parameters based on our constructed pulse generator can be easily adjusted which include voltages, frequencies, pulse widths and polarities. We hope that our work will stimulate the further investigations on design and analysis of pulse generators with a focus on modularization and miniaturization. [ABSTRACT FROM PUBLISHER]

This paper describes a novel MOSFET gate driver circuit design for pulsed power application. It is shown that MOSFET switching speed can be enhanced by using an energised inductor as a high current source in series with the gate terminal of a power MOSFET. This topology demonstrates switching speeds of less than 10ns for MOSFETs with high input gate capacitance. It is also shown that by increasing the current in the gate drive and with an optimised layout, a single gate driver can be used to drive multiple parallel connected MOSFETs synchronously without compromising their performance. The circuit design is analysed and experimental results presented when operating at an instantaneous power of 25 kW. [ABSTRACT FROM AUTHOR]

Capacitor charging power supply (CCPS) is a developed technology that utilizes resonant converters topology for high power applications. This paper proposes new a capacitor charging power supply using leg-rotation control method within a phase-shifted PWM full-bridge dc/dc converter. The capacitor charging power supply was connected in series to increase output voltage. Also, the proposed system is designed with soft switching techniques in order to achieve high efficiency, and a leg-rotation control method was used to reduce the heat generated from the IGBTs. The operation of the converter and design methodology will be described. A simplified model of a high-voltage high-frequency transformer is given and the structure is designed to decrease high-voltage stress. The validity of the proposed system is then verified by experimental results. The performance test of the capacitor charging power supply was carried out with a 2 μF capacitive load with a 20 kV output voltage. [ABSTRACT FROM AUTHOR]

This paper presents a novel topology for the generation of high voltage pulses that uses both slow and fast solid-state power switches. This topology includes diode-capacitor units in parallel with commutation circuits connected to a positive buck-boost converter. This enables the generation of a range of high output voltages with a given number of capacitors. The advantages of this topology are the use of slow switches and a reduced number of diodes in comparison with conventional Marx generator. Simulations performed for single and repetitive pulse generation and experimental tests of a prototype hardware verify the proposed topology. [ABSTRACT FROM AUTHOR]

Improving efficiency and flexibility in pulsed power supply technologies is the most substantial concern of pulsed power systems specifically with regard to plasma generation. Recently, the improvement of pulsed power supply has become of greater concern due to the extension of pulsed power applications to environmental and industrial areas. With this respect, a current source based topology is proposed in this paper as a pulsed power supply which gives the possibility of power flow control during load supplying mode. The main contribution in this configuration is utilization of lowmedium voltage semiconductor switches for high voltage generation. A number of switch-diode-capacitor units are designated at the output of topology to exchange the current source energy into voltage form and generate a pulsed power with sufficient voltage magnitude and stress. Simulations carried out in Matlab/SIMULINK platform as well as experimental tests on a prototype setup have verified the capability of this topology in performing desired duties. Being efficient and flexible are the main advantages of this topology. [ABSTRACT FROM AUTHOR]