Search

This paper discusses the effect of temperature on polarization and depolarization current measurements on paper oil insulation system. The influence of copper sulphide formed due to corrosive sulphur in mineral oil, on the changes in polarization and depolarization current at different temperatures are considered. A significant increase in the magnitude of polarization and depolarization currents due to deposits of copper sulphide on paper layers is observed. The conductivity of paper insulation increases significantly with increase in temperature. The increase in current is attributed to thermally active conducting particles of copper sulphide. The Debye model parameters of equivalent circuit under copper corrosion have been computed and a model for failure due to copper sulphide is explained using the data on polarization and depolarization currents. [ABSTRACT FROM PUBLISHER]

The oil-paper insulation of valve-side windings in a high voltage direct current (HVDC) converter transformer is subjected to both complicated voltage and severe thermal stresses. Partial discharge (PD) occurring in oil-paper bounded cavities is influenced by voltage stress type as well as temperature. This paper presents PD behaviors in an oil-paper bounded gas cavity under pulsating DC voltages. The voltage across the gas cavity and PD inception voltages at different test conditions are analyzed. Influences of temperature on statistical PD distributions and parameters are also presented. A numerical model is used to interpret PD behaviors under pulsating DC voltages and various temperatures. Experimental results and theoretical statements show that the temperature exhibits a great influence on the behaviors of cavity discharge under pulsating DC voltages. Volume resistivity, gas pressure, charge decay time constant, and electron generation rate are the primary parameters influencing PD behaviors at different temperatures. [ABSTRACT FROM PUBLISHER]

Furfural content in oil is a valuable indicator of cellulose paper degradation and is widely utilized in aging assessment for power transformers. However, with the same aging degree of insulation paper, the actual furfural content in oil is influenced by temperature because furfural partitioning behavior in the oil-paper insulation system of power transformers changes with temperature. Thus, correction of the temperature effect on furfural partitioning is crucial for accurate assessment of the aging of power transformers. In this research, oil-paper samples with different furfural contents were prepared through an accelerated thermal aging test. A furfural equilibrium experiment was conducted at different temperatures to construct a furfural partitioning diagram. The mass fraction of furfural in oil and paper was calculated. Results showed that the mass fraction of furfural in oil increases with temperature rising and aging deepening, which means that furfural tends to migrate from paper to oil at high temperatures and deep aging conditions. The change in furfural partitioning between oil and paper at different temperatures causes a deviation in paper aging assessment. To correct the temperature effect on furfural partitioning, a furfural correction factor was developed to normalize furfural contents in oil at different temperatures to a reference temperature. The furfural correction factor was verified by experimental data and then introduced into the relation between degree of polymerization of paper and furfural content of oil. Verification results showed that the corrected equation can enhance the accuracy of paper aging estimation at different temperatures. The findings of this work indicated temperature effect on furfural partitioning should be considered when determining the furfural thresholds and evaluating the aging condition of power transformers. [ABSTRACT FROM PUBLISHER]