Search

The degradation of oil-impregnated paper induced by partial discharge (PD) seriously affects the life of power equipment. In order to investigate the relationship between partial discharge and the degradation of oil-impregnated paper, PD characteristics and trap parameters of the impregnated paper are measured. In this work, a cavity discharge model is adopted and samples with different degrees of polymerization (DP) are fabricated using thermally accelerated aging to simulate transformers with different lifetimes. For each sample, phase resolved partial discharge (PRPD) spectrograms are recorded for various partial discharge times. The characteristics of partial discharge are analyzed, and the trap parameters of specimens are obtained by the thermally stimulated depolarization current (TSDC) method. Following this, the microstructures of the samples are observed using a scanning electron microscope (SEM). It is found that the damaging breakdown process of oil-immersed paper can be divided into three stages: initial stage, developing stage and pre-breakdown stage. There also exist two levels of trap on the surface of oil-impregnated paper: shallow (0.10-0.59 eV) and relatively deep (0.60-0.90 eV) energy. Importantly, the thermal aging makes the trap energy deeper while electrical aging makes the trap energy shallower. [ABSTRACT FROM AUTHOR]

Utility asset managers and engineers are concerned about the life and reliability of their power transformers which depends on the continued life of the paper insulation. The ageing rate of the paper is affected by water, oxygen and acids. Traditionally, the ageing rate of paper has been studied in sealed vessels however this approach does not allow the possibility to assess the affect of oxygen on paper with different water content. The ageing rate of paper has been studied for dry paper in air (excess oxygen). In these experiments we studied the ageing rate of Kraft and thermally upgraded Kraft paper in medium and high oxygen with varying water content. Furthermore, the oxygen content of the oil in sealed vessels is low which represents only sealed transformers. The ageing rate of the paper has not been determined for free breathing transformers with medium or high oxygen content and for different wetness of paper. In these ageing experiments the water and oxygen content was controlled using a special test rig to compare the ageing rate to previous work and to determine the ageing effect of paper by combining temperature, water content of paper and oxygen content of the oil. We found that the ageing rate of paper with the same water content increased with oxygen content in the oil. Hence, new life curves were developed based on the water content of the paper and the oxygen content of the oil. [ABSTRACT FROM PUBLISHER]

Oxidation ageing experiments on paper insulation and transformer oil have been performed using two different techniques. One is a traditional ageing study wherein degree of polymerization (DP) is measured after conditioning in sealed bottles containing paper submerged in oil, where the partial pressure of oxygen over the oil is varied. Paper is sampled at certain intervals during 8 months and DP-values are measured. The other study was carried out by means of a microcalorimeter; continuously measuring the heat flow from the paper-oil sample. We find that the degradation reaction rate is not linear with oxygen concentration and that the activation energy of oxidation is lower than what has earlier been found for hydrolysis. The microcalorimeter appears to mimic ageing characteristics for oxidation and can potentially be a useful tool for quick ageing investigations. [ABSTRACT FROM AUTHOR]