Search

Nowadays, reliability of power system is of great importance. Therefore, the condition of transformers as the expensive and critical components of a power system should be monitored and assessed. The dominant factor that causes limitation in transformers lifetime is the paper insulation. This paper aims to investigate the conspicuous influence of moisture content, especially in low oxygen and temperature on lifetime estimation under constant conditions, based on the results of previous experiments. Degree of polymerization (DP) is employed to quantify the effects of detrimental parameters with respect to their time-varying nature. This paper proposes a novel lifetime estimation-approach considering a yearly moisture growth for transformers. The results indicate different trend of DP profiles, which lead to an accurate lifetime estimation in comparison with DP obtained through ideal conditions. Furthermore, oscillations in the hot-spot temperature of transformers are demonstrated to have a negative effect on the lifetime. [ABSTRACT FROM AUTHOR]

The oil-impregnated paper, as a vital part in the oil-paper insulation system, serves as the main insulation medium in converter transformer suffering various electric fields. However, the accumulated surface charge on the paper would accelerate the degradation of insulation system and may lead to surface flashover. Direct-fluorination is a method to change the chemical components of polymer matrix thus could affect the surface property of the dielectric material without the alternation of bulk property. This paper presents a method to modify the surface structure of the paper applied in transformers. The paper used in the experiment was treated using the F2/N2 mixture with a volume fraction of 10% for the F2 gas at a pressure of 0.05 MPa in a reaction vessel for 2, 5, 10 and 15 min, respectively. The chemical elements, functional group and physical morphology of the paper before and after modification were measured with energy dispersive X-ray spectroscopy (EDAX), attenuated total reflection infrared (ATR-IR) and scanning electron micrographs (SEM), respectively. Surface and volume resistivity of the fluorinated paper were measured. Furthermore, the surface charge property of the oil-impregnated paper was measured under various positive and negative voltages. Obtained results showed that the fluorination had an obvious influence on the chemical property and surface structure of the paper leading to the reduction of surface and volume resistivity. The treatment was shown to reduce the initial potential and cause acceleration in charge decay process. The trap distribution of the paper surface presented alternation as well. [ABSTRACT FROM PUBLISHER]

The application of vibration-based condition monitoring methods to power transformers has shown the potential for detecting mechanical transformer failures. The ageing of winding insulation paper, which is a common problem in long-serving power transformers, affects both the electrical and mechanical strength of the windings. This paper is concerned with the vibration features of winding disks with aged insulation paper. The vibration characteristics of single-layer winding disks wrapped with insulation paper are investigated. By examining the vibration frequency responses of winding disks with different degrees of ageing of insulation paper, the effects of aged paper on the vibration behaviors of winding disks are demonstrated. The experimental results show that changes in the vibration responses of winding disks can be related to the ageing of insulation paper, and thus it is possible to detect this failure mode in a power transformer using a vibration-based method. A qualitative explanation for these changes is presented, using the degradation of the mechanical strength of the insulation paper. [ABSTRACT FROM AUTHOR]

The degradation of oil-impregnated paper induced by partial discharge (PD) seriously affects the life of power equipment. In order to investigate the relationship between partial discharge and the degradation of oil-impregnated paper, PD characteristics and trap parameters of the impregnated paper are measured. In this work, a cavity discharge model is adopted and samples with different degrees of polymerization (DP) are fabricated using thermally accelerated aging to simulate transformers with different lifetimes. For each sample, phase resolved partial discharge (PRPD) spectrograms are recorded for various partial discharge times. The characteristics of partial discharge are analyzed, and the trap parameters of specimens are obtained by the thermally stimulated depolarization current (TSDC) method. Following this, the microstructures of the samples are observed using a scanning electron microscope (SEM). It is found that the damaging breakdown process of oil-immersed paper can be divided into three stages: initial stage, developing stage and pre-breakdown stage. There also exist two levels of trap on the surface of oil-impregnated paper: shallow (0.10-0.59 eV) and relatively deep (0.60-0.90 eV) energy. Importantly, the thermal aging makes the trap energy deeper while electrical aging makes the trap energy shallower. [ABSTRACT FROM AUTHOR]

Heretofore, unlike HVAC transformers, there is not much experience in both insulation design guides and test methods for ultra HV converter transformers. This special insulation phenomenon is very prominent due to the complication of voltage applied on valve-side windings of converter transformers. There is a severe lack of empirical research on partial discharge in oil-paper insulation under the combined ACDC voltage. The study in this paper provides a timely research into the issues. Nine possible configurations, which intent to simulate different defects in the transformer, have been investigated. The PD inception voltages varied ratios of combined AC-DC voltages were conducted. The discharge magnitude and its relation with the applied voltage for selected four common configurations were obtained during voltage increasing and decreasing respectively, which presented the PD initiating process and also reflected the insulation behavior of dielectrics. Besides, the Finite Element Analysis Soft was used to propose the effect of morphology of electrode surface (3 dimensional roughness is approximately 0.03 mm) on PD characteristics, which is very lacking in the previous references. The roles of DC and AC component in PD characteristics were discussed in the context of the relevant work in literatures. [ABSTRACT FROM AUTHOR]

Copper sulfide deposition on cellulosic insulating materials in oil-immersed transformers is evaluated by heating tests stipulated by IEC 62535. Although this method is suitable for evaluation of the corrosivity of unused insulating oil, the subject remains in diagnosis of the insulating oil used. It is because dibenzyl disulfide (DBDS), which is the prime compounds that cause copper sulfide deposition, is consumed by the reaction with copper during operating of transformer. Therefore, it is necessary to detect the existence of DBDS in insulating oil diagnosed as non-corrosivity by IEC 62535. The proceeding paper [6] reports that Bibenzyl (BiBz) and Dibenzyl sulfide (DBS) will be formed in the insulating oil as by-products of copper sulfide formation between copper and DBDS in oxygen-poor atmosphere which imitated the closed-type transformers. These by-products are considered to be the indication of copper sulfide formation. However, the influence of oxygen and addition agent (e.g. 2,6-di-tert-butylp- cresol) on the mechanism of the by-product formation is unclear. The purpose of this study is to elucidate the influence of oxygen and DBPC in by-products formation for development of diagnosis. It became apparent that benzyl alcohol, benzaldehyde and benzoic acid generate as by-products of copper sulfide formation in the air atmosphere which imitated the open-breathing transformers. Furthermore, it became apparent that the reaction product of benzyl radical and the radical of DBPC generates as by-product of copper sulfide formation in the insulating oil containing DBPC. These by-products are detectable even if DBDS disappears. Therefore, it is thought that diagnosis of the open-breathing transformer is possible by detecting these by-products. [ABSTRACT FROM AUTHOR]

A post mortem analysis of scrapped transformers provides an opportunity to directly measure the properties of in-service aged paper insulation. Investigations on 10 scrapped 275 kV and 400 kV power transformers were carried out, where Tensile Index (TI) and Low Molecular Weight Acid (LMA) of the paper insulation sampled from various locations were measured. Multiple-layer TI profile demonstrated the effect of oxidized oil on paper ageing which was confirmed by laboratory ageing experiments. It is LMA rather than High Molecular Weight Acid (HMA) that accelerates the paper degradation. LMA acts as the paper ageing accelerator and also as the paper degradation by-product, supporting the view that self-accelerated hydrolysis process is the main paper ageing mechanism. Finally, a generic relationship between LMA in paper and TI of paper was revealed based on both in-service and laboratory ageing data, i.e. the lower the TI of paper, the higher value of LMA in paper is measured. It implies that LMA in oil can be a potential paper ageing indicator pro viding a link between LMA in oil and paper is found. [ABSTRACT FROM AUTHOR]

Utility asset managers and engineers are concerned about the life and reliability of their power transformers which depends on the continued life of the paper insulation. The ageing rate of the paper is affected by water, oxygen and acids. Traditionally, the ageing rate of paper has been studied in sealed vessels however this approach does not allow the possibility to assess the affect of oxygen on paper with different water content. The ageing rate of paper has been studied for dry paper in air (excess oxygen). In these experiments we studied the ageing rate of Kraft and thermally upgraded Kraft paper in medium and high oxygen with varying water content. Furthermore, the oxygen content of the oil in sealed vessels is low which represents only sealed transformers. The ageing rate of the paper has not been determined for free breathing transformers with medium or high oxygen content and for different wetness of paper. In these ageing experiments the water and oxygen content was controlled using a special test rig to compare the ageing rate to previous work and to determine the ageing effect of paper by combining temperature, water content of paper and oxygen content of the oil. We found that the ageing rate of paper with the same water content increased with oxygen content in the oil. Hence, new life curves were developed based on the water content of the paper and the oxygen content of the oil. [ABSTRACT FROM PUBLISHER]

Oxidation ageing experiments on paper insulation and transformer oil have been performed using two different techniques. One is a traditional ageing study wherein degree of polymerization (DP) is measured after conditioning in sealed bottles containing paper submerged in oil, where the partial pressure of oxygen over the oil is varied. Paper is sampled at certain intervals during 8 months and DP-values are measured. The other study was carried out by means of a microcalorimeter; continuously measuring the heat flow from the paper-oil sample. We find that the degradation reaction rate is not linear with oxygen concentration and that the activation energy of oxidation is lower than what has earlier been found for hydrolysis. The microcalorimeter appears to mimic ageing characteristics for oxidation and can potentially be a useful tool for quick ageing investigations. [ABSTRACT FROM AUTHOR]