Search

Direct power control (DPC) has gained much attention for medium-voltage applications due to its fast power control capability. However, a conventional static switching table based DPC can lead to unsatisfactory response when the converter is connected to an electric grid because it is commonly designed assuming ideal and constant voltages of the grid and the dc link. Therefore, the actual grid voltage and the actual converter dc-link voltage should be considered while designing the switching table. This paper proposes a novel dynamic switching table for the DPC, considering actual grid and dc-link voltages variation. The proposed dynamic switching table incorporates a new definition of power influence crossover angles of each converter space vector. The proposed scheme dynamically adapts the switching table by feeding forward the actual grid and dc-link voltages, and hence the converter's power is precisely controlled. The proposed technique is verified for the three-level neutral point clamped converters connected to a standard IEEE 9-bus test system. Moreover, the real-time simulations are performed in a real-time digital simulator, OPAL-RT. The obtained results verified the effectiveness of the proposed DPC strategy under different grid fault scenarios. [ABSTRACT FROM AUTHOR]

This paper proposes a simplified and improved model predictive current control (MPCC) scheme for grid-connected bidirectional voltage source converter (GC-BVSC) when the unbalanced grid voltages occur. In conditions of unbalanced grid voltage, the current harmonic components of the GC-BVSC increase significantly, and twice grid-frequency ripple exist in both active power and reactive power, which influence the output power quality. To reduce harmonic currents and power fluctuations, an improved MPCC (IMPCC) method is proposed, and a two-step predictive model of GC-BVSC is put forward. The current compensation values are expressed by grid voltages and their quadrature signals that lag 90 electrical degrees in the αβ stationary coordinates system. The cost function reducing both the power ripple and current distortion is designed. Compared to conventional methods, phase-locked loop, pulse width modulation, and complex positive and negative sequence extraction of grid voltage are not required. In addition, IMPCC presents a better performance by reducing both grid-connected current harmonics and power ripple of GC-BVSC with flexible bidirectional power regulation capability. Simulation and experimental results on power electronics-professional (PE-PRO) platform verify the effectiveness of the proposed scheme under both single-phase and three-phase unbalanced grid voltages. [ABSTRACT FROM AUTHOR]

As penetration of distributed generation increases, the electrical distribution networks may encounter several challenges mainly related to voltage control. The situation may deteriorate in case of a weak grid connected to an intermittent source such as photovoltaic (PV) generation. Fast varying solar irradiance can cause unacceptable voltage variations that may not be easily compensated by slow-responding utility equipment. The PV inverter can be used to control the grid voltage by injecting/absorbing reactive power. A small-signal model is derived in order to study the stability of a PV inverter exchanging reactive power with the grid. This paper also proposes a method that utilizes the available capacity of the PV inverter to support the grid voltage without violating the rating of the inverter and the maximum voltage that the inverter's switching device can withstand. The method proposed in this paper is validated using PSCAD/EMTDC simulations. [ABSTRACT FROM PUBLISHER]