Search

For discontinuous conduction mode (DCM) dc–dc converters with digital sensorless current mode (DSCM) control, an observed current error occurs, owing to a low-accuracy current observer. Moreover, a reference current error occurs due to a low-accuracy current controller or a finite dc gain of current loop. Conventionally, the observed current is compensated to increase current regulation accuracy, whereas the reference current error is neglected. However, for charge balance principle (CBP)-based DSCM (CBP-DSCM) control, this paper proves that the reference current should be compensated in a same quantity to that of observed current. Otherwise, single or unequal compensation leads to output voltage steady-state error. For this reason, a dual current error compensation strategy for CBP-DSCM control is proposed. It compensates the errors in a same quantity through a current error observer, which considers parasitics and calculates the current errors without approximation. To verify the proposed strategy, small-signal models with parasitics for both the converter and the controller are constructed by differential functions of key variables. Furthermore, converter stability is analyzed at typical operation condition, while the stability at various operation conditions is verified through robustness analysis. Finally, simulations and experimental results verify the analysis and the improved transient response of the converter. [ABSTRACT FROM AUTHOR]

This paper presents high step-up dc-to-dc converter for low voltage sources such as solar photovoltaics, fuel cells, and battery banks. To achieve high voltage gain without large duty cycle operation, combination of coupled inductor and switched capacitor voltage doubler cells are used. By incorporating active clamp circuit, voltage spike due to the leakage inductance of the coupled inductor is alleviated and zero-voltage switching turn on of the main and auxiliary switch is obtained. Due to the use of MOSFETs of low voltage rating and soft turn on of the switches, conduction loss and switching losses are reduced. This improves the efficiency and power density of the converter. The proposed converter can achieve high voltage gain with reduced voltage stress on MOSFET switches and output diodes. Design and analysis of the proposed converter is carried out, and finally, a 500-W experimental prototype is built to verify theoretical analysis. [ABSTRACT FROM PUBLISHER]