Search

Nonisolated dc–dc converters are fundamental building blocks in the power supply for a wide range of applications. To cater to this heterogeneity in applications, development of dc–dc converters with suitable voltage conversion ratio (G) is imperative. Given a converter topology, G can be found out uniquely by using the principle of inductor volt-second balance, and the process of obtaining the voltage conversion ratio from the topology is simple. In contrast, the inverse problem, i.e., the process of obtaining the converter topology for a given voltage conversion ratio (G) is a challenging task, and the obtained topology is also not unique. This article presents a simple method to obtain a family of converter topologies from a required voltage conversion ratio. This method utilizes the principle of inductor flux balance as a synthesis tool. The step-by-step procedure to synthesize the converter topologies is outlined. To illustrate the efficacy of the proposed method, it is applied to synthesize various quadratic buck–boost topologies, and a family of converters is identified. Operation and feasibility of two novel topologies, identified by the proposed theory, are verified experimentally. [ABSTRACT FROM AUTHOR]

Due to the pulsating power at the inverter output terminals, the passive storage elements of the boost stage of the current-fed switched inverter (CFSI) contain a power frequency harmonic component (100 Hz), apart from dc and switching frequency components. In prior designs, the second harmonic component is suppressed by increasing the size of the input filter inductor and capacitor or by using additional circuits. This paper presents a complete characterization of a control-based approach to suppress the power frequency harmonic component in the input inductor current of a CFSI. It also presents a comprehensive characterization of the harmonic power redistribution. Using the proposed approach, it is demonstrated that the inductor value of a CFSI is reduced by 61% for the same peak-to-peak ripple. This leads to an improvement in the conversion ratio, efficiency, and power density of the overall converter. A SiC MOSFET-based CFSI with 75-kHz switching frequency is used to verify the proposed design philosophy. [ABSTRACT FROM AUTHOR]

The Z-source inverter (ZSI) employs an LC impedance network between the main inverter bridge and the power source. The unique feature of the ZSI is that it can operate either in buck or boost mode with a wide range of obtainable output voltages from a given input voltage. This topology also exhibits better electromagnetic-interference noise immunity when compared to a traditional voltage-source inverter (VSI). However, the LC impedance network of ZSI significantly increases the size and cost of the power converter and can make it unsuitable for low-power applications. This paper proposes a novel topology called switched boost inverter (SBI) which exhibits similar advantages of ZSI with lower number of passive components and more active components compared to ZSI. The steady-state and small-signal analyses of SBI, along with its pulsewidth modulation (PWM) control strategies, have been discussed in this paper. This paper also presents a comparison of SBI and ZSI with the same input and output parameters. The theoretical analysis given in this paper has been validated using a laboratory prototype of SBI, and the experimental results are presented for verification. The experimental harmonic spectrum of the inverter's output voltage with the proposed PWM technique is also plotted and compared with that of a traditional VSI. All the experimental results show good correlation between theory and experiments. [ABSTRACT FROM PUBLISHER]