Search

Low-voltage ride-through (LVRT) requirements demand wind-power plants to remain connected to the network in presence of grid-voltage dips. Most dips present positive-, negative-, and zero-sequence components. Hence, regulators based on symmetrical components are well suited to control grid-connected converters. A neutral-point-clamped topology has been considered as an active front end of a distributed power-generation system, following the trend of increasing power and voltage levels in wind-power systems. Three different current controllers based on symmetrical components and linear quadratic regulator have been considered. The performance of each controller is evaluated on LVRT requirement fulfillment, grid-current balancing, maximum grid-current value control, and oscillating power flow. Simulation and experimental results show that all three controllers meet LVRT requirements, although different system performance is found for each control approach. Therefore, controller selection depends on the system constraints and the type of preferred performance features. Index Terms--Distributed power generation, grid interface, multilevel conversion, three-level inverter, wind-power system.

In photovoltaic (PV) power systems where a set of series-connected PV arrays (PVAs) is connected to a conventional two-level inverter, the occurrence of partial shades and/or the mismatching of PVAs leads to a reduction of the power generated from its potential maximum. To overcome these problems, the connection of the PVAs to a multilevel diode-clamped converter is considered in this paper. A control and pulsewidth-modulation scheme is proposed, capable of independently controlling the operating voltage of each PVA. Compared to a conventional two-level inverter system, the proposed system configuration allows one to extract maximum power, to reduce the devices voltage rating (with the subsequent benefits in device-performance characteristics), to reduce the output-voltage distortion, and to increase the system efficiency. Simulation and experimental tests have been conducted with three PVAs connected to a four-level three-phase diode-clamped converter to verify the good performance of the proposed system configuration and control strategy. Index Terms--Four-level three-phase diode-clamped dc-ac converter, multilevel, photovoltaic-array (PVA) voltage control, photovoltaic (PV) energy, pulsewidth modulation, renewable energy, virtual vectors.

This paper presents a novel approach for the connection of renewable energy sources to the utility grid. Due to the increasing power capability of the available generation systems, a three-level three-phase neutral-point-clamped voltage-source inverter is selected as the heart of the interfacing system. A multivariable control law is used for the regulator because of the intrinsic multivariable structure of the system. A current source (playing the role of a generic renewable energy source) is connected to the grid using a three-level inverter in order to verify the good performance of the proposed approach. Large-and small-signal d--q state-space averaged models of the system are obtained and used to calculate the multivariable controller based on the linear quadratic regulator technique. This controller simultaneously regulates the dc-link voltage (to operate at the maximum power point of the renewable energy source), the mains power factor (the power is delivered to the grid at unity power factor), and the dc-link neutral-point voltage balance. With the model and regulator presented, a specific switching strategy to control the dc-link neutral-point voltage is not required. The proposed controller can be used for any application, since its nature makes possible the control of any system variable. The good performance of the presented interfacing solution in both steady-state and transient operation is verified through simulation and experimentation using a 1-kW neutral-point-clamped voltage-source-inverter prototype, where a PC-embedded digital signal processor board is used for the controller implementation. Index Terms--Distributed power generation, grid interface, multilevel conversion, multivariable control, photovoltaic power system, three-level inverter, wind power system.

This paper presents a novel pulsewidth modulation (PWM) strategy for n-level three-leg semiconductor-clamped dc–ac converters in the overmodulation region, with dc-link capacitor voltage balance in every switching cycle. The strategy is based on the virtual-vector concept. Suitable reference vector trajectories are selected to obtain low weighted total harmonic distortion and a simple algorithm. A hexagonal-boundary compression factor is introduced to guarantee, at any operating point, dc-link capacitor voltage regulation capabilities in every switching cycle and avoid narrow gate pulses. The detailed PWM algorithm for an easy implementation in a digital control platform is also presented. The good performance of the strategy is verified through both simulation and experiments in a three-level three-phase neutral-point clamped converter. [ABSTRACT FROM PUBLISHER]

This paper presents a novel multilevel active-clamped converter topology, which is an extension to m levels of the three-level active neutral-point-clamped topology. The operating principle is established through the definition of a proper set of switching states and a transition strategy between adjacent switching states. The benefits of the proposed converter topology and control in comparison to alternative multilevel converter topologies are discussed. The simulation and experimental results of a simple four-level dc–dc converter configuration are presented to illustrate the converter performance features. The experimental results of a four-level three-phase dc–ac converter are also presented to further validate the proposed topology and operating principle. [ABSTRACT FROM AUTHOR]

This paper presents a closed-loop control scheme for the three-level three-phase neutral-point-clamped dc-ac converter using the optimized nearest three virtual-space-vector pulsewidth modulation, which is a modulation that produces low output-voltage distortion with a significant reduction of the dc-link capacitance. A new specific loop modifying the modulating waveforms is proposed to rapidly control possible perturbations in the neutral-point voltage balance. An online estimation of the load displacement angle and load linear/nonlinear nature is introduced at no extra cost. The remaining part of the control is analogous to the control for a two-level converter with an appropriate interfacing to the selected modulation. The closed-loop control is designed for the case of a renewable-energy source connected to the ac mains, and its performance is analyzed through simulation and experiments. [ABSTRACT FROM AUTHOR]