Search

In this paper, the design of the one-cycle controller of a single-stage inverter for photovoltaic applications is carried out by means of a multiobjective strategy to optimize inverter performance at both high and low insolation levels. Design constraints that account for different weather conditions are adopted. The optimization algorithm also provides useful information concerning the system sensitivity with respect to each of the controller parameters. This allows the design of a maximum power point tracking perturb and observe controller that significantly improves inverter performance. Experimental measurements confirm the predictions of theoretical and simulation results. Index Terms--Maximum power point tracking (MPPT) techniques, one-cycle control (OCC), photovoltaic (PV) inverter.

One of the major drawbacks of photovoltaic (PV) systems is represented by the effect of module mismatching and of partial shading of the PV field. Distributed maximum power point tracking (DMPPT) is a very promising technique that allows the increase of efficiency and reliability of such systems. Modeling and designing a PV system with DMPPT is remarkably more complex than implementing a standard MPPT technique. In this paper, a DMPPT system for PV arrays is proposed and analyzed. A dc and small-signal ac model is derived to analyze steady-state behavior, as well as dynamics and stability, of the whole system. Finally, simulation results are reported and discussed. Index Terms--Distributed generation, maximum power point tracking (MPPT) techniques, photovoltaic (PV) systems.

Power processing systems will be a key factor of future photovoltaic (PV) applications. They will play a central role in transferring, to the load and/or to the grid, the electric power produced by the high-efficiency PV cells of the next generation. In order to come up the expectations related to the use of solar energy for producing electrical energy, such systems must ensure high efficiency, modularity, and, particularly, high reliability. The goal of this paper is to provide an overview of the open problems related to PV power processing systems and to focus the attention of researchers and industries on present and future challenges in this field. Index Terms--Inverters, maximum power point tracking (MPPT), photovoltaic (PV) systems, power electronics, power processing, solar energy.

The nine papers in this special section focus on photovoltaic module and sub-module level power electronics. Grid connected photovoltaic energy systems have experienced an explosive growth over the last decade, with a cumulative installed capacity surpassing the 400 GW milestone as of 2017. Among PV system configurations, distributed module-level converter architectures can lead to a higher energy yield by mitigating partial shading, persistent shading (soiling, snow, bird droppings, and fallen leaves), mismatch, and aging, through a higher maximum power point tracking (MPPT) efficiency. Also, distributed electronics might be the key for implementing diagnostic and prognostic actions at a module level. Among these configurations, microinverters (also known as ac-module inverter), which connect a single PV module to the grid, and PV power optimizers, which are dc–dc converters performing the MPPT function at a module level, have attracted the academic and industrial interest in the last decade. So much so, that both microinverters and dc–dc power optimizers are commercialized by tens of companies around the world, with a great variety of circuit topologies, which comprise combinations of one or more power stages, interleaved converters, resonant converters, topologies with and without isolation, etc. [ABSTRACT FROM AUTHOR]

This paper presents a novel method to design the output filter of low-voltage/high-current buck dc-dc switching regulators. The method is based on the concept of acceptability boundary curves (ABCs). ABCs are the curves bounding the regions in the space of parameters, including commercial components which ensure an acceptable output voltage ripple and a load-transient surge based on design specifications. ABCs help in quickly finding tradeoff design solutions, as well as in a better understanding of the functional correlations among power components. Examples regarding buck converters for point-of-load applications are discussed to highlight the flexibility and reliability of the ABC-based design method. Experimental measurements confirm the analytical results and numerical predictions. [ABSTRACT FROM AUTHOR]