Search

In this paper, the characteristics of ripple current of a multimegawatt drive system fed by a pulse-width modulation (PWM) inverter are investigated. Based on the investigation, a novel PWM scheme is devised to reduce the switching loss of the inverter under an identical amount of torque ripple of a motor. The proposed PWM is composed of two parts. The first is minimum torque ripple PWM (MTRPWM), which is optimized in terms of the minimum torque ripple in high modulation index (MI). The second determines the minimum switching frequency while holding the average torque ripple less than the allowable value under various operating conditions. It is termed reduced switching frequency PWM (RSFPWM). Consequently, by simply changing the PWM method from conventional fixed switching frequency continuous PWM to the proposed PWM, MTRPWM and RSFPWM, simulation results show that the switching loss of the inverter driving a 3.5 MW induction motor is reduced to 51.6% while keeping the torque ripple in the allowable boundary, where MI is 1.12. This approach is applied to small-scale experimental sets consisting of an interior permanent magnet synchronous machine (IPMSM) motor-generator set, and an induction machine MG set in an effort to verify the validity and feasibility of the proposed method. Based on these experimental results, the cost indexes of the IPMSM and the induction machine, as defined in this paper, decrease by up to 66% and 77%, respectively, when the proposed method is applied when MI is 1.12 compared with the outcome with the conventional PWM. [ABSTRACT FROM AUTHOR]

This paper introduces a three-phase grid-connected inverter for commercial-scale photovoltaic systems. The circuit topology combines an ac-inductor-less active bridge with a parallel-connected pulsewidth modulation inverter acting as an instantaneous reactive power compensator. The active bridge, called a 120° conduction inverter, operates at a switching frequency equal to the grid frequency and outputs a 120° rectangular current, while the compensator eliminates the harmonic currents included in the rectangular current. The main advantage of this strategy is the reduction in size of the required ac inductor by a factor of 4, as well as the reduction of power losses in the switching devices. The theoretical analysis clearly shows that the compensator can synthesize a sinusoidal output current by controlling only instantaneous reactive power, thus eliminating the need for electrolytic capacitors. A 5-kW experimental setup validates the operating principle and the control method of the proposed inverter and exhibits an inverter efficiency as high as 99.2% with Si superjunction mosfets. [ABSTRACT FROM AUTHOR]

An optimal current control strategy for asymmetrical hybrid multilevel inverters (MLIs) is proposed in this paper enabling their use on motor drives, static synchronous compensators, and photovoltaic and wind generators, where a fast and precise current regulation is required. A key feature of these highly efficient converters is that an ac machine (motor or transformer) operates according to an open-end winding configuration, connected on one side to a main MLI and, on the other side, to an auxiliary two-level inverter (TLI). The first efficiently controls the main power stream operating at a low switching frequency, while the TLI acts as an active power filter, exploiting a conventional high-frequency two-level pulsewidth modulation (PWM) technique. The proposed control scheme optimally exploits the key features of the two inverters by suitably sharing the control task. In fact, a predictive current control is assigned to the MLI, which can be accomplished by low switching frequency operations, while the high switching frequency of the PWM-operated TLI is exploited to accomplish a fast and precise closed-loop current control, processing only a part of the power stream flowing through the system, thus producing low power losses. Simulations and experimental results confirm the consistency of the proposed approach. [ABSTRACT FROM AUTHOR]

Paralleled inverters are not only a suitable approach to increase the power capacity, but also have the capability of common mode voltage (CMV) reduction, or even elimination. The original zero CMV modulation scheme for paralleled inverters suffers from the current jump problem in phase-leg currents. This current jump phenomenon amplifies the peak values of differential-mode circulating current (DMCC) and zero-sequence circulating current (ZSCC), which is adverse for the design of coupled inductor and common-mode inductor. This paper introduces the modified modulation scheme, which can keep volt-seconds balance in whole fundamental period and mitigate the current jump in phase-leg currents. In addition, the reduction effect of the DMCC and ZSCC can be achieved. To verify the analysis, both the simulation and experimental results are presented, which validates the proposed methods and show that they are beneficial for DMCC and ZSCC reduction. [ABSTRACT FROM AUTHOR]

One of the problems of the pulse-width-modulation (PWM)-controlled ac machines is the acoustic noise that could become unacceptable when used in sensitive environments. Random PWM (RPWM) in industrial and commercial adjustable-speed drives (ASD) results in the partial transfer of power from the discrete spectrum (narrowband noise) of the output voltage to the continuous spectrum (wideband noise), with advantageous effects on reducing the acoustic noise in the motor drive system. In this paper, the theoretical power spectrum analysis as the basis for RPWM is presented. Five state-of-the-art RPWM strategies, their voltage, current, and acoustic noise spectra characteristics are quantitatively evaluated. The PWM schemes and theoretical analysis are validated through a 2.2-kW 380-V 50-Hz ASD induction machine experimental setup. The results provide valuable data for practicing engineering community to choose the best option in real-world applications. [ABSTRACT FROM PUBLISHER]

Operating a dual three-level inverter system from a single dc link circuit is an economic solution for generating five-level output voltage waveforms and to double the output power compared to a single three-level inverter. Such an inverter system is used for feeding a drive motor with open stator windings. A mechanism is then required to reduce the common-mode voltage components of the motor voltages. This paper describes an offline optimization method that minimizes both the harmonic distortion of the motor currents and the common-mode voltage components. The optimization permits reduction of the switching frequency to a very low value of 200 Hz without compromising the harmonic distortion. High performance operation of the drive system at low switching frequency is experimentally demonstrated. [ABSTRACT FROM PUBLISHER]