Search

A switching-capacitor-based buck–boost converter (with common ground) for point of load applications is proposed in this paper. It is capable of operating in stand-alone buck or boost mode in addition to its primary operation of performing the buck–boost conversion. The striking feature of the proposed converter is low source current ripple content irrespective of its mode of operation (buck–boost, buck, or boost). First, feasible pulsewidth modulation schemes for the proposed converter are identified and thereafter the corresponding circuit performance analysis, steady-state analysis, and state-space modelling is established. Through steady-state analysis, voltage gain expressions are formulated and equations defining L-C components are derived in terms of their ripple quantities. The state-space models are used to formulate small-signal analysis and to obtain the relevant transfer functions required in the controller design. A voltage-mode/current-mode controller is designed, with a tradeoff in bandwidth, to control the proposed converter and transit it from buck to boost mode or vice versa seamlessly. A 30–55 W, 100 kHz, prototype point of load converter with 36-V input dc source is built to supply power at constant load voltage of either 48 or 28 V. The proposed converters’ effectiveness is demonstrated experimentally in terms of reduced source current ripple along with seamless transition from buck to boost mode and vice versa. [ABSTRACT FROM AUTHOR]

This paper investigates a multilevel inverter composed of series/parallel-connected H-bridges. The presented structure can be used for applications in which the use of semiconductor switches with low-voltage and low-current ratings is intended. A comprehensive system model, an overall control strategy to adjust the output voltage with constant magnitude and frequency, and a level-shifted PWM (LS-PWM) strategy based on a voltage vectors unidimensional analysis and a plane analysis are presented. The LS-PWM is capable of mitigating the low-frequency circulating current, thus generating multilevel voltage signals with low harmonic distortion, maximum number of levels, and low dv/dt. In addition, considering a wide range of values of voltages and currents and various power levels, the total converter losses are reduced compared with the conventional multilevel converters. Two multilevel conventional inverters with the same number of semiconductor switches are used for comparison. Simulation and experimental results demonstrate the feasibility of the studied converter. [ABSTRACT FROM AUTHOR]

Although the operation of a three-phase current source rectifier (CSR) for ac-to-dc conversion using phase control or low-frequency pulse control is well established in a wide variety of applications, CSR realization using high-frequency pulsewidth-modulation control has been recently studied as a potentially competitive alternative to a voltage source rectifier. In the CSR, reverse blocking gate turn-off switches are realized using series-connected diodes, which prevent any reversal of the dc-link current. A significant consequence of this limitation occurs at light load conditions. The dc-link inductor current enters the discontinuous mode of operation and leads to the loss of the control of the output voltage and a highly distorted input current, which compromise the potential advantages of the approach. This paper characterizes the CSR while operating in the discontinuous conduction mode and proposes a modulation strategy that restores the control of the output voltage and ensures a nearly sinusoidal current at light loads. Simulation and hardware results are provided for a 3-kW laboratory-scale prototype system. [ABSTRACT FROM AUTHOR]

This paper proposes a zero-voltage-transition (ZVT) pulsewidth-modulated (PWM) synchronous buck converter, which is designed to operate at low voltage and high efficiency typically required for portable systems. A new passive auxiliary circuit that allows the main switch to operate with zero-voltage switching has been incorporated in the conventional PWM synchronous buck converter. The operation principles and detailed steady-state analysis of the ZVT PWM synchronous converter with a passive auxiliary circuit are presented. All of the semiconductor devices aside from the main switch operate under soft-switching conditions. Thus, the auxiliary circuit provides a larger overall efficiency. The feasibility of the auxiliary circuit is confirmed by the simulation and experimental results. [ABSTRACT FROM PUBLISHER]