Search

This paper demonstrates low-loss acoustic delay lines (ADLs) based on shear-horizontal waves in thin-film LiNbO3 for the first time. Due to its high electromechanical coupling, the shear-horizontal mode is suited for producing devices with large bandwidths. Here, we show that shear-horizontal waves in LiNbO3 thin films are also excellent for implementing low-loss ADLs based on unidirectional transducers. The high acoustic reflections and large transducer unidirectionality induced by the mechanical loading of the electrodes on a LiNbO3 thin film provide a great tradeoff between delay line insertion loss and bandwidth. The directionality for two different types of unidirectional transducers has been characterized. Delay lines with variations in the key design parameters have been designed, fabricated, and measured. One of our fabricated devices has shown a group delay of 75 ns with an IL below 2 dB over a 3-dB bandwidth of 16 MHz centered at 160 MHz (fractional bandwidth = 10%). The measured insertion loss for other devices with longer delays and different numbers of transducer cells are analyzed, and the loss contributing factors and their possible mitigation are discussed. [ABSTRACT FROM AUTHOR]

This paper demonstrates the first nonreciprocal network based on switched low-loss acoustic delay lines. The four-port circulator is built upon a recently reported frequency-independent, programmable, nonreciprocal framework based on switched delay lines. The design space for such a system, including the origins of the insertion loss (IL) and harmonic responses, is theoretically investigated, illustrating that the key to better performance and low-cost modulation signal synthesis lies in a large delay. To implement a large delay, we resort to in-house fabricated low-loss, wideband lithium niobate (LiNbO3)SH0 mode acoustic delay lines employing single-phase unidirectional transducers. The four-port circulator, consisting of two switch modules and one delay line module, has been modularly designed, assembled, and tested. The design process employs time-domain full circuit simulation, and the results match well with measurements. An 18.8-dB nonreciprocal contrast between IL (6.6 dB) and isolation (25.4 dB) has been achieved over a fractional bandwidth of 8.8% at a center frequency 155 MHz, using a record low switching frequency of 877.19 kHz. The circulator also shows 25.9-dB suppression for the intramodulated tone and 30 dBm for IIP3. Upon further development, such a system can potentially lead to future wideband, low-loss chip-scale nonreciprocal radio frequency systems with unprecedented programmability. [ABSTRACT FROM AUTHOR]

This paper presents the first demonstration of nanowatt-level CMOS wakeup receiver (WuRx) front ends (FEs) that utilize microelectromechanical system (MEMS)-based matching networks (MNs). The first FE uses a fully MEMS-based MN (MMN) that operates at 88.8 MHz. It consists of a large array of lithium niobate resonators that are fabricated on the same die. Measurements of the integrated WuRx FE with the MMN indicate that its loaded voltage gain achieves a bandwidth of 0.78 MHz with a quality factor of 114. The second FE uses a hybrid MN (HMN) that operates at 457 MHz. It consists of an aluminum nitride laterally vibrating resonator as well as eight discrete inductors and capacitors surrounding the MEMS device. Measurements of the integrated WuRx FE with the HMN indicate that it achieves a sensitivity of −54 dBm with 7 nW of average dc power consumption without a digital correlator. [ABSTRACT FROM AUTHOR]