Search

A 700-kA gas switch with graphite electrodes for pulsed power supply module has been developed. This paper describes the design, construction, and testing of the high-current gas switch and its trigger system. The two-electrode gas switch is selected, which suffers high peak and fast rise time currents. The trigger generator based on resonant charging of a pulse transformer is constructed to trigger the gas spark. An electrodynamic force model of switch electrodes is established. The electrodynamic force of connecting wires is also calculated. By comparison of the mechanical strengths of polyformaldehyde, epoxy, and fiber-reinforced plastic (FRP) rods, where FRP rods are selected as switch rods, the experimental results show that the mechanical strength of the switch increases by 200%. Extensive electric testing has proven the operating parameters of the switch and its trigger system. The experimental results show that the measured discharge current waveform is demonstrated to be over a 700-kA peak current and a 500- \mu \texts pulsewidth. The transfer charge per shot is more than 500 C. [ABSTRACT FROM PUBLISHER]

Starting from the updated requirements of an advanced laser system, a switch–trigger system for a 2.0-MJ pulsed power supply (PPS) module is developed. This paper discusses the design, construction, and testing of this switch–trigger system. The two-electrode construction for the spark gap switch is selected because of its superiority in terms of long working life, high peak currents, and fast rise time of currents. The trigger generator based on resonant charging of a pulse transformer is constructed. A magnetic isolator and a pressure controller are the auxiliary equipment of this system. In the section based on mathematical principles, the equations of the lifetime and stability of this spark gap switch with graphite electrodes are given. These expressions can be regarded as the design basis of the same type of switch. As for the trigger generator, the analysis states that an appropriate ratio can be obtained when using the resonant charging based on a core-type pulse transformer. The charging time is dependent on the leakage inductance and the capacitance of the primary and secondary capacitors. Extensive testing proves the operating parameters of the switches and the trigger generator. The measured discharge current waveform of the 2.0-MJ capacitive PPS module is demonstrated to be over 500 kA peak current and 500 \mus pulse width. The life test proves that the switch–trigger system can support more than 200 kC transfer charge. By replacing the electrodes, the lifetime of this switch can be extended furthrer. [ABSTRACT FROM PUBLISHER]