Search

This paper proposes a flyback-circuit-based design of a trigger circuit for a high-power gas switch. By incorporating a flyback circuit in a high-power gas switch, it is possible to generate a high step-up ratio and high-voltage pulse by using a transformer. Furthermore, simple trigger circuit having the minimum possible number of components (transformer and switch) can be realized. When an inductor is used as an energy storage element, energy is stored as a current source, and thus, the element can operate reliably when low impedance exists between the trigger node of the switch after triggering. According to the fundamental operating principle of a flyback circuit, the proposed trigger circuit is designed considering the maximum trigger voltage and energy required for a high-power gas switch. To verify the proposed design procedure and feasibility of the trigger circuit, a compact trigger circuit (7.5 kV, 1.3 mJ/pulse) is simulated using the PSpice program and implemented. Based on this compact circuit, a trigger circuit (20 kV, 100 mJ/pulse) for a triggered vacuum switch (TVS) is developed, and the tests with an actual TVS (3.3 kJ) are carried out. [ABSTRACT FROM AUTHOR]

In this paper, a 25-kW bipolar pulsed-power supply for strategic mineral exploration has been described. A 500-V, 12.5-A unit module consisting of a highly efficient LCC resonant converter and a full-bridge-based bipolar pulse-switching unit is designed. The LCC resonant converter has a trapezoidal-shaped resonant current for reduced conduction loss. For achieving high power density, the leakage inductance of the transformer is used as resonant inductance without an external inductor. Moreover, the designed gate drive circuit based on the repetitive short pulse is proposed to operate the frequency range from dc to 8 kHz and reduce the size of the gate transformer. Four modules are connected in series and parallel in order to operate the power supply in either loop mode or grounded dipole mode. Depending on the load condition, the pulse power source capable of delivering the required high voltage and low current (2 kV, 12.5 A) or low voltage and high current (500 V, 50 A) is operated either in grounded dipole mode or loop mode, respectively. In order to satisfy the output voltage balancing of the four modules, the third wire is wound to compensate for the transformer of the LCC resonant converter. Finally, the design of the bipolar pulsed-power supply has been verified based on the experimental results of the field test. [ABSTRACT FROM AUTHOR]