Search

The first series tube of the gyrotrons for the 10-MW electron cyclotron resonance heating system of the stellarator W7-X was tested at Forschungszentrum Karlsruhe (FZK) and yielded a total output power of 0.98 MW, with an efficiency of 31% (without a single-stage depressed collector) in short-pulse operation and of 0.92 MW in pulses of 180 s (efficiency of almost 45% at a depression voltage of 29 kV). The Gaussian mode output power was 0.91 MW. The pulselength at full power (1 MW) is limited at FZK by the available power supply. At a reduced electron beam current, it is possible to operate at longer pulselengths. At an output power of 0.57 MW (electron beam current of 29 A), the pulselength was increased to 1893 s. There was no physical reason for a limitation of this pulse: The pressure increase during the pulse was less than a factor of two and ended up at a very low value in the [10.sup.-9] mbar range. The tube was delivered to Max-Planck-Institut fur Plasmaphysik Greifswald for tests at full power and up to 30-min pulselength. The Gaussian mode RF output power, measured in a calorimetric load after a 25-m-long quasi-optical transmission line (seven mirrors), was 0.87 MW at a total output power of 0.92 MW in 30-min pulses. Again, no indications for a limitation in pulselength were found. The second series tube was tested in short-pulse operation and showed a strange behavior concerning a mode hopping which has not yet been understood. The third series gyrotron delivers up to now 0.65 MW at a pulse duration of 180 s. Preliminary operation of the prototype tube as a two-frequency gyrotron delivered 0.41 MW in 10-s pulses at 103.8 GHz (T[E.sub.21,6] mode). Index Terms--Chemical-vapor deposition (CVD)-diamond window, frequency step tuning, gyrotron, high-power microwaves, quasi-optical (q.o.) mode converter, single-stage depressed collector (SDC), stray radiation.

In the first part of this paper, the status of the 140-GHz continuously operated gyrotrons with an output power of 1 MW or the stellarator Wendelstein 7-X will be described. With the first series tube, an output power of 1000 kW has been achieved in short pulse operation (milliseconds) with an electron beam current of 40 A, and of 1150 kW at 50 A. With a pulse length of 3 min limted by the available high-voltage (HV) power supply, an output power of 920 kW at an electron beam current of about 40 A with an efficiency of 45% and a mode purity of 97.5% has been obained. At a reduced beam current of 29 A, an output power of 570 kW was measured with a pulse length of 1893 s without significant increase in tube pressure. The energy content of this pulse is almost 1.1 GJ. For the next fusion plasma device, International Thermonuclear Experimental Reactor (ITER), gyrotrons with a higher output power of about 2 MW are desirable. In short-pulse experiments, the feasibility of the fabrication of coaxial cavity gyrotrons with an output power up to 2-MW, continuous wave (CW), has been demonstrated, and the information necessary for a technical design has been obtained. The development of a long-pulse 2-MW coaxial cavity gyrotron started within a European coopera tion. In parallel to the design and fabrication of an industrial prototype gyrotron, a short-pulse preprototype gyrotron has been operated to verify the design of critical components. An output power of 1.2 MW with an efficiency of 20% has been achieved. The development of frequency tunable gyrotrons operating in the range from 105 to 140 GHz for stabilization of current driven plasma instabilities in fusion plasma devices (neoclassical tearing modes) is another task in the development of gyrotrons at the Forschungszentrum Karlsruhe. Index Terms--Coaxial gyrotron, diamond window, frequency tuning, gyrotron, high-power microwaves, quasi-optical mode converter, single-stage depressed collector, step tunability, stray radiation.