Search

This paper investigates the Multilevel Current Source Converter (MCSC) STATCOM. It proposes a new method of modulation. The new modulation method produces less THD and di/dt at the terminals of the MCSC STATCOM when compared to the widely used Phase-Shifted Carrier SPWM (PSC-SPWM). To ensure the inductors' currents remain balanced, a Current Balancing Algorithm (CBA) is presented. The CBA does not require any controls. It relies on assigning optimum switching states to each CSC module in real-time. In addition, two control strategies are presented in this paper. The first one assumes the STATCOM to be a SISO. Therefore, it only requires one PI controller. However, the gains for the controller must be changed if the STATCOM was to transition from capacitive mode to inductive mode, or vice versa. The second control strategy overcomes this problem by implementing a TITO integral state feedback controller. The contributions of this paper are validated via simulation and experimental results. [ABSTRACT FROM AUTHOR]

This paper describes a modified phase-shifted carrier-based pulsewidth-modulation (PSC-PWM) scheme for modular multilevel converters (MMC). In order to reduce the average device switching frequency, a reduced switching-frequency (RSF) voltage balancing algorithm is developed. This paper also proposes a circulating current suppressing controller (CCSC) to minimize the inner circulating current in an MMC. Based on the double line-frequency, negative-sequence rotational frame, the three-phase alternative circulating currents are decomposed into two dc components and are minimized by a pair of proportional integral controllers. Simulation results based on a detailed PSCAD/EMTDC model prove the effectiveness of the modified PSC-PWM method and the RSF voltage-balancing algorithm. The proposed CCSC not only eliminates the inner circulating current but also improves the quality of the converter ac output voltage. A simple loss evaluation demonstrates that the RSF voltage-balancing algorithm and the CCSC reduce the converter power losses. [ABSTRACT FROM AUTHOR]

The modular multilevel converter (MMC) is a newly introduced switch-mode converter topology with the potential for high-voltage direct current (HVDC) transmission applications. This paper focuses on the dynamic performance of an MMC-based, back-to-back HVDC system. A phase-disposition (PD) sinusoidal pulsewidth modulation (SPWM) strategy, including a voltage balancing method, for the operation of an MMC is presented in this paper. Based on the proposed PD-SPWM switching strategy, a mathematical model for the MMC-HVDC system, under both balanced and unbalanced grid operation modes, is developed. Dynamic performance of the MMC-based back-to-back HVDC converter system, based on time-domain simulation studies in the PSCAD/EMTDC environment, is then evaluated. The reported time-domain simulation results show that based on the adopted PD-SPWM switching strategy, the MMC-HVDC station can respond satisfactorily to the system dynamics and control commands under balanced and unbalanced conditions while maintaining voltage balance of the dc capacitors. [ABSTRACT FROM PUBLISHER]

The three-phase series-connected modular multilevel converter (SC-MMC) is presented as one option for high-voltage direct current (HVDC) tap to reduce the cost of an HVDC station. Compared with conventional three-phase parallel-connected MMC, the number of semiconductor switches in SC-MMC is reduced by one-third to withstand the same dc voltage. First, the paper studies the operating principle of SC-MMC, and then presents an interspacing phase-shifted pulsewidth-modulated method which could improve the waveform of the output ac voltage for a given switching frequency. Next, the control strategy based on the identical real power input of each phase is proposed to balance the dc voltage of each phase under an unbalanced grid condition. The current limit of switching devices is also taken into consideration to protect SC-MMC from overcurrent. Furthermore, a universal zero-sequence current controller is developed as one part of the control strategy. In addition, an innovative method to suppress the third harmonics of ac current is presented. With the third harmonic suppression strategy, the SC-MMC can operate with much smaller SM capacitors without deteriorating the ac current, which contributes to the cost reduction further. Finally, simulation results obtained in PSCAD/EMTDC are provided to validate the proposed control strategies. [ABSTRACT FROM PUBLISHER]

This paper presents a neutral point voltage control strategy for the three-level active neutral point clamped (ANPC) converter using selective harmonic elimination pulsewidth modulation (SHE-PWM). The control strategy introduces a small change in the switching angles, which varies the duty cycle of the zero-level switching state, controls the neutral point current and, therefore, the neutral point voltage. The decision to vary a given switching angle takes into account the polarity of the output currents and the voltage across the lower dc-link capacitor. The effectiveness of the proposed strategy is verified through extensive simulation studies and experimentally validated using a low power laboratory prototype. [ABSTRACT FROM AUTHOR]