Search

High entrance capacitances of ultrahigh-voltage (UHV) transformers make it difficult to generate impulses with standard front time during the lightning impulse tests. In this paper, we discuss the feasibility of examining the longitudinal insulation design of a transformer via impulses with a front time longer than the standard value. We consider the following features: transient voltage distributions and insulation characteristics of longitudinal insulation. The transient voltages of two UHV windings are measured with a capacitive voltage sensor under impulses with different front times. The results demonstrate that the front time of the applied impulse has little effect on the gradient voltage distributions and the oscillatory component of the transient voltage, but it determines the front time of transient voltages. Therefore, the relationship between breakdown characteristics of the turn-to-turn insulation and the front time is studied. Experimental results revealed that whatever the insulation thickness, an increase in the front time of the applied impulse decreases the breakdown voltage, but this variation is within acceptable tolerance when the front time changes from 1.2 μs to 6 μs. Thus, as long as the front time is restricted within 6 μs, we can ensure the validity of lightning impulse tests on the examination of longitudinal insulation designs. [ABSTRACT FROM AUTHOR]

In this paper, we present an update to the models used to calculate the remaining life of transformer paper insulation. A drawback to the current IEEE method is that it does not take into account the availability of water and oxygen on the life expectancy of Kraft paper insulation. We therefore set out to test an algorithm which does take these into account. For our investigation, we loaded three test transformers and ran them to near their end of life. Kinetic equations were applied to model the fall in the degree of polymerization of paper. Our model showed better agreement with the test results than that given from using the IEEE standard. The IEEE standard gives life expectancy for Kraft paper being aged in minimal oxygen under dry conditions, which is not necessarily representative of an old transformer. Wet paper and using high levels of oxygen can age nearly 40 times faster. The IEEE method needs to take the synergistic effect of water and oxygen on increasing the rate of paper aging into account. [ABSTRACT FROM PUBLISHER]

In this paper, we discuss a better method to measure the paper water content of transformers using cellulose isotherms. The advantage of the new method is that the transformer oil and cellulosic insulation do not need to be in thermodynamic equilibrium. Instead, the temperature needs to be cycling in order to determine when the direction of water migration, whether out of or into the oil changes. The reversal in water migration can be used to determine the vapor pressure of the water adsorbed by the cellulose. This method was tested using 12 different conditions similar to those within a normally operating transformer. The results showed close agreement when this method is used. The significance is that isotherm equations can now be used even when insulation media are not in equilibrium. [ABSTRACT FROM PUBLISHER]