Search

This paper proposes fault-tolerant (FT) operation of a single-switch dc-dc converter under a switch failure. In order to improve the reliability in critical applications, FT operation is mandatory to guarantee service continuity. The FT operation of a power system can be performed in three steps: fault diagnosis (detection and identification) and remedial actions. In the case of a switch failure, suitable fault detection is essential to avoid its propagation to the whole system. This study is based on a fast and efficient open- and short-circuit switch fault diagnosis. Both types of switch failure can be detected, identified, and handled in real time by implementing fault diagnosis and reconfiguration strategies on a field-programmable gate array target. No additional sensor is required to perform the fault detection. A redundant switch and a bidirectional switch are needed for converter reconfiguration in postfault operation. The results of hardware-in-the-loop and experimental tests, which all confirm the good performances of the proposed approach, are presented and discussed. [ABSTRACT FROM AUTHOR]

In this paper, the general design of a battery buffer system (BBS) consisting of a dc/dc converter and electric double layer capacitors for an electric vehicle is presented. This is intended to save the regenerative braking energy and to support the battery during acceleration. The design of a multiphase converter in interleaved operation with nonideal coupled inductors is stated to minimize volume and power losses while maintaining given current ripple limitations. A reduced sensor current-sharing control method is developed and its correct choice of the sensor position is explained. The peak efficiency of the designed and built converter can be measured to nearly 99%. The corresponding BBS is implemented in a lead-acid battery powered electric lift truck propulsion system. The system operation with and without the BBS is compared to examine the behavior and the overall efficiency. It can be shown that the traction battery stress can be strictly reduced as well as the temperature rise in the battery. Furthermore, the efficiency can be increased in the range of 5-6%. The battery's lifetime improvement is estimated by means of the difference in the temperature rise to approximately 20%. [ABSTRACT FROM AUTHOR]