Search

This paper proposes fault-tolerant (FT) operation of a single-switch dc-dc converter under a switch failure. In order to improve the reliability in critical applications, FT operation is mandatory to guarantee service continuity. The FT operation of a power system can be performed in three steps: fault diagnosis (detection and identification) and remedial actions. In the case of a switch failure, suitable fault detection is essential to avoid its propagation to the whole system. This study is based on a fast and efficient open- and short-circuit switch fault diagnosis. Both types of switch failure can be detected, identified, and handled in real time by implementing fault diagnosis and reconfiguration strategies on a field-programmable gate array target. No additional sensor is required to perform the fault detection. A redundant switch and a bidirectional switch are needed for converter reconfiguration in postfault operation. The results of hardware-in-the-loop and experimental tests, which all confirm the good performances of the proposed approach, are presented and discussed. [ABSTRACT FROM AUTHOR]

Power-electronics-based hybrid dc power systems (HDCPSs) are increasingly used in many industrial applications such as land, sea, and air vehicles. In these systems, small dc-link and LC filter capacitors are of great interest for weight saving. Usually, in HDCPSs, there are constant power loads and negative dynamic impedance of these loads may generate unstable oscillations. Besides, the risk of resonance may be increased under unbalanced load conditions. In this paper, a distributed active oscillation suppression approach is presented. It is based on the analytical study of the linearized model of the studied system around the operating point. The studied system consists of one main dc source and one storage element supplying two loads: a permanent magnet synchronous motor connected to the dc link by a voltage source inverter and a resistive load supplied by a dc/dc converter through the same dc bus. The proposed approach is particularly used to overcome the resonance under unbalanced load conditions and allows reducing dc link and LC filter capacitors for weight saving. Simulations and experimentations are carried out which confirm the validity of the proposed approach. [ABSTRACT FROM AUTHOR]