Search

A novel high-conversion-ratio bidirectional dc–dc converter with coupled inductor is proposed in this paper. Compared with the bidirectional converters based on coupled inductor, this new topology can realize a higher step-up voltage gain and lower step-down voltage gain with a lower turn ratio in an appropriate duty cycle. In proposed converter, the windings of the coupled inductor are reversely connected to transfer energy from high voltage source or low voltage source. Then, a clamp capacitor is applied to reduce voltage stress on main switch; therefore, the conduction loss of the main switches can be reduced by using a low resistance switch, and the clamp capacitor can also recycle the energy of the leakage inductor in coupled inductor. Besides, the soft-switching technique is used to achieve zero voltage switching, so the efficiency can be further improved. The main circuit and its steady-state operating principle are analyzed in detail. Finally, a 25–200 V 200 W bidirectional dc–dc converter is implemented to verify its performance. [ABSTRACT FROM AUTHOR]

A new three-level dc/dc converter is proposed in this paper. The outstanding features of this converter are that it operates with zero-voltage-switching (ZVS) from full-load to near no-load conditions with hardly any circulating freewheeling primary current due to its novel structure. Since the converter has little primary circulating current and its switches are exposed to only half of the input voltage, it has high efficiency even under light loads. In this paper, the new converter is introduced, its basic operating principles are explained, its modes of operation and its steady-state characteristics are discussed in detail as is its design, and experimental results obtained from a prototype converter that confirm its feasibility are presented. [ABSTRACT FROM AUTHOR]

This paper presents a soft-switching pulsewidth modulation (PWM) nonisolated boost dc–dc converter embedding an edge-resonant switched capacitor (ER-SWC) cell and its interleaved circuit topology. The conceptual boost dc–dc converter treated herein can achieve high-frequency zero-current soft-switching turn-on and zero-voltage soft-switching turn-off operations in the active switches and minimization of a reverse recovering current in the freewheeling diode under discontinuous conduction mode partially including critical conduction mode in the input current. Those advantageous properties enable a wide range of soft-switching operations together with a high-voltage step-up conversion ratio with a reduced current stress. Circuit design guideline based on the soft-switching range is introduced; then, a theoretical analysis is carried out for investigating the step-up voltage conversion ratio. For demonstrating the effectiveness of the ER-SWC soft-switching PWM boost dc–dc converter and its newly developed interleaved topology, laboratory prototypes are evaluated in experiments; then, their performances are discussed from a practical point of view. [ABSTRACT FROM PUBLISHER]

In this paper, a soft-switching bidirectional dc/dc converter with a LC series resonant circuit is proposed. The proposed converter has been obtained by adding LC series resonant tank in the conventional bidirectional dc/dc converter. The proposed topology performs soft switching at both buck and boost operations. Through the theoretical boost and buck mode analysis, zero voltage switching operation is explained. Moreover, characteristics of the proposed topology are verified with simulation and experimental results. [ABSTRACT FROM AUTHOR]