Search

This paper presents an online procedure for the automatic search of the maximum-torque-per-ampere operating region for a synchronous reluctance motor. The algorithm is based on a signal-injection method with a random-based perturbation pattern applied to a common direct-torque-controlled drive. Among motor parameters, only the stator resistance is required to perform the automatic procedure. Simulations and experimental results are presented in the paper, demonstrating the benefits of the proposed algorithm. The solution is easily extended to any ac drive. [ABSTRACT FROM PUBLISHER]

This paper proposes a technique for accelerating the convergence to the maximum power point of photovoltaic (PV) systems based on the model obtained from manufacturer’s generator data. The influence of the temperature over the PV array performance is considered, and no measurement of solar radiation is required. Knowledge of the load model and expensive sensor circuitry are not necessary. The tracking speed is much faster than nonmodel-based techniques at the expense of an increase in the computational complexity. Simulation and experimental results are presented and demonstrate the feasibility of the proposed solution. [ABSTRACT FROM AUTHOR]

The precise information of permanent-magnet synchronous generator (PMSG) rotor position and speed is essentially required to operate it on maximum power points. This paper presents an adaptive network-based fuzzy inference system (ANFIS) for speed and position estimation of PMSG, where an ANFIS-based model reference adaptive system is continuously tuned with actual PMSG to neutralize the effect of parameter variations such as stator resistance, inductance, and torque constant. This ANFIS-tuned estimator is able to estimate the rotor position and speed accurately over a wide speed range with a great immunity against parameter variation. The proposed system consists of two back-to-back connected inverters, where one controls the PMSG, while another is used for grid synchronization. Moreover, in the proposed study, the grid-side inverter is also utilized as harmonic, reactive power, and unbalanced load compensator for a three-phase, four-wire (3P4W) nonlinear load, if any, at point of common coupling (PCC). This enables the grid to always supply/absorb a balanced set of fundamental currents at unity power factor. The proposed system is developed and simulated using MATLAB/SimPowerSystem (SPS) toolbox. Besides this, a scaled laboratory hardware prototype is developed and extensive experimental study is carried out to validate the proposed control approach. [ABSTRACT FROM PUBLISHER]