Search

A single-stage, bidirectional, current-source converter (CSC) topology to interface a dc microgrid with an ac grid is reported in the literature. In this topology, under a balanced grid voltage condition, the dc-link inductor current can be regulated over a wide range—from zero to rated value—while the ac-side current has low harmonic distortion. However, unbalanced grid voltages result in second-harmonic pulsation in the current and power on the dc side of the converter. In addition, the ac-side currents will be unbalanced due to the presence of a negative-sequence component. This would result in undesired tripping of the converter if one of the phase currents exceeded its rated value. Various control loop structures for the operation of voltage-source converter under unbalanced grid voltage conditions are reported in the literature. However, use of similar control loop structures for CSC may lead to unstable operation. Therefore, a control scheme to inject balanced three-phase currents into the ac grid under an unbalanced grid voltage condition is proposed in this paper. The stability of the proposed control scheme is studied using a small-signal model of the converter. Performance of the proposed control scheme is studied using MATLAB/Simulink and is experimentally validated. [ABSTRACT FROM AUTHOR]

A paralleled multilevel inverter topology consists of n three-phase three-level current-fed inverters (CFIs) connected in parallel on ac side. AC currents with (2n+1) levels can be generated utilizing redundant switching states when all three-level inverters have equal dc-link currents. However, the multilevel space vector diagram gets modified, redundancy in the switching states is lost and the multilevel current pattern changes when the dc-link current of all inverters is not the same. This introduces low-frequency harmonics in output current, thereby deteriorating total harmonic distortion (THD). The presence of low-frequency components in the output current could be avoided by selecting suitable switching state vectors and ensuring proper time sharing among these vectors. Two methods to select such switching state vectors are proposed in this paper. In the first method, a reference current space vector is realized using the nearest switching state vectors. However, this method results in low-frequency pulsation in dc-link voltage of each inverter. In the second method, the switching state vectors are chosen to eliminate this low-frequency pulsation. Effectiveness of these methods is experimentally validated for a five-level CFI. Further, performance of these methods is compared based on efficiency, THD, and dc-link voltage ripple for various inequality ratios in dc-link currents. [ABSTRACT FROM AUTHOR]

DC microgrids are gaining popularity due to high efficiency, high reliability, and easy interconnection of renewable sources as compared to the ac system. Control objectives of dc microgrid are: 1) to ensure equal load sharing (in per unit) among sources; and 2) to maintain low-voltage regulation of the system. Conventional droop controllers are not effective in achieving both the aforementioned objectives simultaneously. Reasons for this are identified to be the error in nominal voltages and load distribution. Though centralized controller achieves these objectives, it requires high-speed communication and offers less reliability due to single point of failure. To address these limitations, this paper proposes a new decentralized controller for dc microgrid. Key advantages are high reliability, low-voltage regulation, and equal load sharing, utilizing low-bandwidth communication. To evaluate the dynamic performance, mathematical model of the scheme is derived. Stability of the system is evaluated by eigenvalue analysis. The effectiveness of the scheme is verified through a detailed simulation study. To confirm the viability of the scheme, experimental studies are carried out on a laboratory prototype developed for this purpose. Controller area network protocol is utilized to achieve communication between the sources. [ABSTRACT FROM AUTHOR]