Search

Dual three-phase (DTP) permanent magnet synchronous machines (PMSM) have been utilized in many applications due to their outstanding performance. However, large stator current harmonics limit the further application of the DTP-PMSM due to the low impedance in the harmonic subspace. To solve this problem, this article proposes a current harmonic suppression strategy based on an extended state observer (ESO). A detailed analysis is carried out to demonstrate the disturbance rejection ability and robustness of the proposed method. The theoretical analysis also shows that the ESO strategy outstands the conventional proportional-integral controller and advanced proportional resonance (PR) controller in terms of harmonic reduction. The advantages are verified by simulation and experimental results under different operating conditions. The proposed strategy still works well when considering other factors that may cause harmonic distortion, such as magnetic circuit saturation, saliency ratio, over-modulation of the inverter, the voltage drop caused by electric devices, and dead time. Meanwhile, some limitations are also pointed out. The proposed strategy can also be easily applied to other multiphase PMSM types. [ABSTRACT FROM AUTHOR]

For the purpose of increasing the reliability in a hostile environment, techniques of fault diagnosis have been reported for a three-phase voltage-source inverter (VSI). Based on the average current Park's vector method, this paper proposes a fuzzy-based fault diagnosis method for the VSI in the three-phase permanent-magnet synchronous motor drive. By utilizing the phase current information, the fault symptom variables are calculated by using the average current Park's vector method. The fuzzy logic approach is applied to process the fault symptom variables and obtain the faulty information of power switches. Compared with other fuzzy logic methods, the fuzzy logic design, fuzzy inputs, and fuzzy rules are different. The proposed fault diagnosis method can detect and locate not only the single or multiple open-circuit faults, but also the intermittent faults in power switches, which can improve the reliability of the motor drive system. The effectiveness of the proposed method is validated by both simulation and experiments. [ABSTRACT FROM AUTHOR]

For the purpose of reducing cost and volume, as well as to increase reliability in hostile environments, techniques of reconstructing three-phase current through a single current sensor have been reported for a three-phase alternating current motor vector control system. Based on the phase current reconstruction method, this paper proposes a novel open-circuit fault diagnosis method for the low-power voltage source inverter in the three-phase permanent-magnet synchronous motor drive. Other than sampling the single dc-link current sensor, the zero voltage vector sampling method (ZVVSM) is adopted to implement the fault diagnosis. By placing the single current sensor at a special position, ZVVSM is able to sample current during the two zero voltage vectors and reconstruct the three-phase currents. The reconstructed three-phase currents are used to generate the diagnostic variables that can detect and locate the faulty power switches. The PWM modulation strategy remains unchanged in this method and the reconstructed phase currents are with less waveform distortion and less harmonic contents, which are suitable for the fault diagnosis. The effectiveness of the proposed method is verified by experiments. [ABSTRACT FROM AUTHOR]

For the purpose of reducing cost and volume, techniques of reconstructing three-phase currents through a single current sensor have been reported for permanent magnet synchronous motor vector control system. In existing studies, the reconstruction precision is largely affected by the dead zones in space vector PWM plane, which requires additional efforts to compensate the dead zones either by modifying pulse width modulation (PWM) modulation strategy or by phase-shifting of PWM signal. In this paper, a novel zero voltage vector sampling method (ZVVSM) is proposed, which can move the current reconstruction dead zones in low modulation region and sector boundary regions toward the outline of the space vector hexagon without modifying PWM signal. By arranging the single current sensor at a novel position, the proposed method is able to sample current in two zero voltage vectors (ZVV). ZVVSM avoids the complicated algorithms as well as the increase of the switching times, so that it is beneficial to the PMSM drive performance. The proposed method is validated by both simulation and experiments. [ABSTRACT FROM AUTHOR]