Search

The fault-tolerant control method of dual three-phase permanent-magnet synchronous motor (PMSM) drives has gained more and more attention in some applications, such as aircraft system and offshore wind energy system. In this letter, the reason for the torque ripple caused by the standard control method has been investigated in view of the frequency domain after the occurrence of a single open-phase fault. Based on the theoretical analysis, a universal control scheme has been proposed for the dual three-phase PMSM drives with two isolated neutral points, which can be implemented under either healthy condition or fault condition. The key is to modify with a closed-loop controller on harmonic subspace with the notch filter. The proposed method not only realizes the seamless transition between two operation conditions without fault diagnosis but also avoids the reconfiguration of the control structure. Moreover, the system optimization of the minimum copper loss under postfault condition has been integrated into the proposed method. The experimental results are presented to illustrate the effectiveness of the proposed method. [ABSTRACT FROM AUTHOR]

In this article, the control strategy is studied for the neutral-point-clamped three-level inverter-fed dual three-phase permanent-magnet synchronous motor (PMSM) drive with low switching frequencies. An interleaved finite-control-set model predictive control (MPC) scheme is proposed, where a two-layer MPC is designed to solve the multiobjective optimization problem. The two sets of windings in PMSM are sampled and controlled in an interleaved way so that the control delay and the prediction horizon of the drive system are reduced by half. Moreover, the proposed interleaved control scheme increases the equivalent sampling and control frequency from the perspective of the whole drive system, and thus provides better steady-state performance and dynamic performance. With the switching states of one inverter remaining unchanged, the cross traversal of vector candidate sets between two sets of windings is avoided, and the computational burden can be reduced effectively. Experimental results are given to verify the validity and effectiveness of the proposed interleaved control scheme. [ABSTRACT FROM AUTHOR]