Search

This paper proposes the new clamping angle control (CAC) pulse width modulation (PWM) method to restore its maximum linear modulation range of voltage source inverters (VSIs) reduced by the duty ratio limitation in hardware implementation, which makes the VSIs to operate nonlinearly in the high modulation range. The deadtime and the bootstrap gate driver circuit mainly cause this duty ratio limitation in practice. In particular, the bootstrap gate driver circuit is used in many industrial applications by avoiding the additional power supply to apply the gate-source voltage of power switches, and therefore making the VSIs to be small size with the low cost. First, the proposed CACPWM method is theoretically analyzed. Then, it is applied in the high modulation range to overcome the limitation of the duty ratio due to the use of the bootstrap gate driver circuit. Thereafter, its practical effectiveness is verified by both simulation and experimental tests. Also, the resulting harmonic distortions are compared with those by the conventional PWM methods. [ABSTRACT FROM AUTHOR]

The purpose of neutral-point voltage balancing algorithms in the three-level neutral-point clamped (3L-NPC) topology is to eliminate the voltage unbalance of top- and bottom-side dc-link voltages (neutral-point voltage). These algorithms are divided into dc unbalance and ac unbalance compensation methods. The dc unbalance causes distortion of output currents; therefore, this problem has to be solved. The ac unbalance implies that there is an ac ripple in the top- and bottom-side dc-link voltages. In applications using 3L-NPC topology, a large dc-link capacitor value is required to mitigate this ac unbalance problem. As a result, the size and the cost of applications become large and expensive. In this paper, a compensation method for mitigating the ac unbalance of the neutral-point voltage is proposed, which causes the dc-link capacitor value to be small, when a carrier-based pulse width modulation method is applied. The proposed method compensates the ac unbalance of the neutral-point voltage by adding an optimal compensation value to the reference duty signals. This compensation value is calculated simply by currents and reference duty signals. The calculation process of the optimal compensation value is discussed, and the effectiveness of the proposed method is verified with simulations and experiments. [ABSTRACT FROM PUBLISHER]

This paper proposes a novel discontinuous pulse-width modulation (DPWM) method to reduce the current harmonics and improve the system efficiency for a single-phase three-level neutral-point clamped inverter. In single-phase inverters, the unipolar pulse-width modulation (UP-PWM) method is commonly used. However, this method has the disadvantage of power losses due to numerous switching operations. Conventional DPWM methods reduce the power losses and improve efficiency but increase the current total harmonic distortion (THD). To overcome these weaknesses, this paper proposes a hybrid DPWM switching method combining two PWM methods: the UP-PWM method and the conventional DPWM method called one-pole clamped PWM method. Since the proposed DPWM method offers all the advantages of both PWM methods, the optimal performance—with regard to the power losses and current THD—is obtained. The combination of two PWM methods is investigated by analyzing the power losses and current THD. Based on the analysis, the process determining the optimal operating condition is introduced. The effectiveness of the proposed DPWM method is demonstrated through simulations and experiments. [ABSTRACT FROM AUTHOR]