Search

Owing to high driving power, good controllability, and strong fault-tolerant ability, a three-phase open-end winding permanent magnet synchronous motor driven by a dual inverter with common dc bus is considered as a competitive solution. However, a path for zero-sequence current is provided in this drive topology. Thus, the system loss would be increased, and the maximum output power is limited. In order to suppress the zero-sequence current, a novel space vector pulsewidth modulation (SVPWM) strategy based on the hysteresis controller of zero-sequence current is proposed in this paper. The voltage vectors, whose polarity of zero-sequence voltages (ZSVs) is opposite with the polarity of zero-sequence current, are selected as the basic voltage vectors of SVPWM for fundamental plane. Meanwhile, the linear modulation range is analyzed. According to the analysis results, the proposed strategy has the advantage of wide linear modulation range of ZSV under the condition of high fundamental modulation ratio. The experimental results show that the zero-sequence current is effectively suppressed by the proposed modulation strategy. Furthermore, the comparative evaluation of the proposed modulation strategy, the conventional SVPWM, the SVPWM with zero ZSVs, and the zero vector redistribution SVPWM with zero-sequence current proportional-resonant controller is conducted to demonstrate the superiority of the proposed strategy. [ABSTRACT FROM AUTHOR]

This paper presents a single-phase to three-phase adjustable-speed drive (ASD) system, which consists of a diode rectifier and a single-stage boost inverter without electrolytic capacitors (E-caps). The system has no shoot-through issues and gains high reliability due to the shoot-through zero-state regulation method. By using electrolytic capacitors-less topology, the lifetime can be greatly increased. By properly designing the tapping position of the inductor, the system has a high boost-inversion gain and can ride through grid voltage sags. By using the proposed harmonic injection method, the system can realize high input power factor and small dc-link ripple voltage, simultaneously. Experimental results of the electrolytic capacitors-less single-stage boost inverter (E-caps-less SSBI) based single-phase to three-phase ASD system are obtained to verify the actual performances. [ABSTRACT FROM AUTHOR]

This letter presents a modulation technique for the modified coupled-inductor single-stage boost inverter (CL-SSBI)-based grid-connected photovoltaic (PV) system. This technique can reduce the system leakage current in a great deal and can meet the VDE0126-1-1 standard. To maintain the advantages of the impedance network, only a diode is added in the front of the original topology, to block the leakage current loop during the active vectors and open-zero vectors. On the other hand, the near-state pulse width modulation (NSPWM) technique is applied with one-leg shoot-through zero vectors in order to reduce the leakage current through the conduction path in the duration of changing from and to open-zero vectors. Simultaneously, the leakage current caused by other transitions can also be reduced due to the fact that the magnitude of common-mode voltages is reduced. Simulation results of the transformerless PV system are presented in two cases: modified CL-SSBI modulated by maximum constant boost (MCB) control method and NSPWM. Experimental results for both CL-SSBI topology modulated by the MCB control method and modified CL-SSBI topology modulated by NSPWM are also obtained to verify the accurateness of theoretical and simulation models. [ABSTRACT FROM AUTHOR]