Search

To obtain a full exploitation of battery potential in energy storage applications, an accurate modeling of electrochemical batteries is needed. In real terms, an accurate knowledge of state of charge (SOC) and state of health (SOH) of the battery pack is needed to allow a precise design of the control algorithms for energy storage systems (ESSs). Initially, a review of effective methods for SOC and SOH assessment has been performed with the aim to analyze pros and cons of standard methods. Then, as the tradeoff between accuracy and complexity of the model is the major concern, a novel technique for SOC and SOH estimation has been proposed. It is based on the development of a battery circuit model and on a procedure for setting the model parameters. Such a procedure performs a real-time comparison between measured and calculated values of the battery voltage while a PI-based observer is used to provide the SOC and SOH actual values. This ensures a good accuracy in a wide range of operating conditions. Moreover, a simple start-up identification process is required based on battery data-sheet exploitation. Because of the low computational burden of the whole algorithm, it can be easily implemented in low-cost control units. An experimental comparison between SOC and SOH estimation performed by suggested and standard methods is able to confirm the consistency of the proposed approach. [ABSTRACT FROM AUTHOR]

In this paper, an innovative converter topology is presented that allows to improve the performance of electronically commutated motor drives, aimed to equip home appliances. The proposed topology is based on a modified C-dump converter configuration, where the energy recovery stage acts as an active power factor controller (PFC) for offline operation. This is made possible by introducing a new technique to manage the free-wheeling energy that is recovered back to the dc bus by a suitable high frequency (HF) transformer. The proposed approach allows to omit the PFC stage that is included in motor drives devoted to home appliance applications in order to comply with power quality requirements. Moreover, the proposed converter topology features only low side or high side configuration switches, allowing to simplify the design of the drive and easily integrate the power semi-conductors in a single chip exploiting smart power technologies. Simulations and experimental results confirm the validity of the proposed approach. [ABSTRACT FROM AUTHOR]

An open-end winding machine configuration and a suitable control strategy for medium-voltage ac motor drives applications are proposed in this paper in order to reduce the distortion of phase voltages in multilevel inverters (MLIs). Differently than standard open-end winding configurations, where two inverters provide active power to both sides of the stator winding, a main MLI supplies in this case the machine on one side, while an auxiliary two-level inverter acts as active power filter on the other side. A high efficiency step modulation manages the MLI, while the auxiliary unit is pulse width modulation (PWM) operated. As the phase current harmonic content is improved, the torque ripple is reduced and the drive efficiency is increased. By exploiting the proposed approach, the apparent switching frequency of the system is that typical of a PWM inverter, although the main unit is operated according to a voltage step modulation strategy. Simulation and experimental results confirm the consistency of the proposed methodology. [ABSTRACT FROM PUBLISHER]