Search

A novel method is proposed to locate the source of events in power distribution systems by using distribution-level phasor measurement units, a.k.a., micro-PMUs. An event in this paper is defined rather broadly to include any major change in any component across the distribution feeder. The goal is to enhance situational awareness in distribution grid by keeping track of the operation (or misoperation) of various grid equipment, assets, distribution energy resources, loads, etc. The proposed method is built upon the compensation theorem in circuit theory to generate an equivalent circuit to represent the event by using voltage and current synchrophasors that are captured by micro-PMUs. Importantly, this method makes critical use of not only magnitude but also synchronized phase angle measurements, thus, it justifies the need to use micro-PMUs, as opposed to ordinary RMS-based voltage and current sensors. The proposed method can work with data from as a few as only two micro-PMUs. The effectiveness of the developed method is demonstrated through computer simulations on the IEEE 123-bus test system, and also on micro-PMUs measurements from a real-life 12.47 kV test feeder in Riverside, CA. The results verify that the proposed method is accurate and robust in locating the source of different types of events on power distribution systems. [ABSTRACT FROM AUTHOR]

The European Union is targeting a 20% share of energy from renewable resources by 2020, and this increase is in turn expected to lead to operational challenges that will require various congestion management actions by system operators. In this paper, we deal with topology control of the transmission network as a congestion management resource and evaluate the impacts of topology control on the European electricity network. To do this, we co-optimize unit commitment and transmission switching over 24 h, and we use a decomposition scheme to tackle the resulting large-scale problem. Our analysis is conducted on different scenarios of load and renewable power generation. We find that topology control results in significant cost savings within Europe which tend to be inversely related to net load. The robustness of our results is supported by an extensive sensitivity analysis. [ABSTRACT FROM AUTHOR]

Optimal transmission switching (OTS) optimizes simultaneously the generation dispatch and the topology of a power system. It has been shown that taking some transmission lines out of service can significantly reduce the operating cost of the system while respecting the traditional deterministic N-1 security criterion of operational reliability. However, topology modifications could adversely affect probabilistic security metrics. The operational reliability of a power system can be translated into a cost by multiplying the expected energy not served by the value of lost load. This paper therefore explores whether it is possible to maintain a positive economic balance with OTS when considering not only the cost of generation but also the expected socio-economic cost of disruptions in the supply. This is done in two steps: the computation of an N-1 secure OTS and then the calculation of a probabilistic estimate of the operational reliability of the OTS solution. Based on the results obtained with two test systems, it is shown that OTS tends to significantly degrade probabilistic measures of security. It is thus not obvious that OTS can lead to a positive economic balance, even when N-1 security is enforced. Consequently, a probabilistic security analysis should be performed before implementing an OTS solution. [ABSTRACT FROM AUTHOR]

This paper proposes a two-level voltage controller for large-scale power systems. The aim of the controller is to maintain a near-optimal voltage profile in the transmission network by coordinating discrete reactive power (var) control devices in the system. The controller is targeted for implementation in electric power transmission utility companies where most of the voltage controls are coordinated by switching of discrete var devices such as shunt capacitor and reactor banks and transformer banks load tap changers (LTCs). By effectively dividing the controller responsibilities between local substation controls and a central coordinator at control center level, the design is aimed at voltage control of large-scale power systems. At local level, the substation controllers maintain their respective substation bus voltages by local power-flow-like computations using mostly local PMU measurements. The central coordinator computes and provides the voltage set-points to the substation controllers and also coordinates by enabling or disabling the local controllers as needed. The controller is being designed towards prototype implementation in Southern California Edison (SCE), starting with local controllers at specific substations in the first stage. It is tested on real-time dynamic models and large-scale power-flow simulations of SCE transmission network. [ABSTRACT FROM AUTHOR]

In power system operation, network topology optimization (NTO) based on bus-branch model and opening/closing transmission lines has been previously proposed and utilized as a congestion mitigating tool to reduce operation cost. The bus-branch model cannot provide a detailed picture of all substation switching actions (e.g., bus splitting) that are well known to operators. In this paper, an NTO model based on substation and node-breaker modeling is presented to relieve congestion and consequently reduce cost. The substation reconfiguration provides a practical and realistic picture of switching actions, while having a higher flexibility in switching actions. However, due to introducing more number of nodes and binary variables associated with breakers, solving an NTO model would be challenging. Therefore, some tightening bounds are presented to maintain the reliability and accelerate the computations. Furthermore, using sensitivity analysis of substations, a method to cluster the network to congestion zones is then employed to determine suitable candidate substations for reconfiguration, thus significantly reducing the number of binary variables associated with breaker switchings. The results of applying the NTO model to the IEEE 118-bus test system demonstrate the effectiveness of the proposed method to remove congestion, while utilizing less number of switching actions compared to bus-branch switching. [ABSTRACT FROM AUTHOR]

The subsynchronous resonance (SSR) problem may become more serious with the continuous evolvement of a series-compensated power system. Consequently, the existing SSR mitigation scheme might no longer keep the system stable. This issue has been encountered by Shangdu Power Plant, where the deployed supplementary excitation damping controllers (SEDCs) that well stabilized the system before cannot maintain torsional stability after the recent change occurred in the power system. Therefore, a combined mitigation scheme of SEDC and generator terminal subsynchronous damping controller (GTSDC) is proposed in this paper to regain system stability. SEDC provides electrical damping by modulating the excitation voltage at the rotor side. Meanwhile, GTSDC can damp SSR via injecting super-synchronous and subsynchronous currents into the generator stator. Field tests have proven the effectiveness of this combined scheme in addressing the deteriorated SSR issue. Eigenvalue analysis indicates that the combined scheme can provide enough positive damping for the system under any operating condition. Thanks to the low investment of SEDC and the flexibility of GTSDC, this combined scheme provides an economical and scalable solution for SSR mitigation, especially when the target system changes constantly. [ABSTRACT FROM AUTHOR]

A hierarchical decentralized network reconfiguration approach to minimize power losses for smart distribution systems was presented in Part I. In this paper, the proposed approach is applied to four test distribution systems to examine its performance. A demonstration system consisting of the test system and distributed intelligent agents is built using MATLAB/Simulink to illustrate how the decentralized approach is implemented. Simulation results of the proposed approach are then compared with results of a centralized implementation and the harmony search method. It is shown that the decentralized approach can achieve similar results as other methods with significantly reduced computation time. The impacts of time-varying loads and faults are also studied through dynamic network reconfiguration on the 118-bus test system. Simulation results illustrate that dynamic network reconfiguration with time-ahead planning can determine the optimal configuration for each operating period to significantly reduce system energy losses. The enhanced performance of the hierarchical decentralized approach is clearly established. [ABSTRACT FROM PUBLISHER]

This paper proposes a new transmission-constrained unit commitment method that combines the cost-efficient but computationally demanding stochastic optimization and the expensive but tractable interval optimization techniques to manage uncertainty on the expected net load. The proposed hybrid unit commitment approach applies the stochastic formulation to the initial operating hours of the optimization horizon, during which the wind forecasts are more accurate, and then switches to the interval formulation for the remaining hours. The switching time is optimized to balance the cost of unhedged uncertainty from the stochastic unit commitment against the cost of the security premium of the interval unit commitment formulation. These hybrid, stochastic, and interval formulations are compared using Monte Carlo simulations on a modified 24-bus IEEE Reliability Test System. The results demonstrate that the proposed unit commitment formulation results in the least expensive day-ahead schedule among all formulations and can be solved in the same amount of time as a full stochastic unit commitment. However, if the range of the switching time is reduced, the hybrid formulation in the parallel computing implementation outperforms the stochastic formulation in terms of computing time. [ABSTRACT FROM PUBLISHER]

This paper deals with the management of voltage constraints in active distribution systems that host a significant amount of distributed generation (DG) units. To this end we propose a centralized optimization approach which aims at minimizing the amount of MW curtailment of non-firm DG to remove voltage constraints. The salient feature of this approach is that it comprehensively and properly models the full variety of possible control means (i.e., DG active/reactive power including DG shut-down, on load tap changing transformer ratio, shunt capacitor, and remotely controlled switches or breakers), most of which having a discrete behavior. We develop and compare the performances of two optimization models on a snapshot basis for various distribution systems up to 1089 buses. In particular we show that the use of remotely controlled switches so as to transfer DG between feeders in case of voltage constraints may lead to significant reduction of the DG curtailment. [ABSTRACT FROM AUTHOR]

Due to the variety of distribution generation (DG) sizes and technologies connecting to distribution networks, and the concerns associated with out-of phase reclosing, anti-islanding continues to be an issue where no clear solution exists. This paper presents an autoground approach that was proposed in the context of an IEEE working group on best practices for DG protection. A prototype system was constructed using standard distribution apparatus and a recloser controller, and it was tested on the utility's distribution test line. Results show that the anti-islanding detection time is approximately a cycle longer than the delay associated with application of the autoground. Once the autoground was applied, the DG was disconnected within 1 cycle on overcurrent protection. The solution is inherently scalable, applicable to all DG types, is configurable to various reclosing practices and does not require additional equipment or settings changes at the producer's site. [ABSTRACT FROM AUTHOR]

Due to the lack of feeder corridors, the Chinese utility companies frequently choose the technique of putting multiple overhead feeders on a same tower (MFST) to meet the load demand in a heavy load area. In many situations, the distance among the feeders of MFST in an electrical distribution network (EDN) is usually too small to meet the requirements of safety regulation for repairing and maintenance. Therefore, when a fault occurs on a feeder of MFST, the other feeders have to be in a triggered passive outage (TPO) state to assist the repairing of the failed feeder. This paper presents a reliability evaluation algorithm for EDNs containing MFST using the section technique. The definition of TPO and the equivalent TPO rate and TPO duration are also proposed. Based on the TPO parameters and the section technique, the reliability evaluation algorithm containing the MFST can be obtained. Case studies on the modified RBTS-BUS6 and the EDNs of three districts in Dongguan city, China, show that the MFST has a significant impact on the EDN reliability and should be considered in the reliability evaluation. The results also show the effectiveness and applicability of the proposed approach. [ABSTRACT FROM PUBLISHER]

Frequency in large power systems is usually controlled by adjusting the production of generating units in response to changes in the load. As the amount of intermittent renewable generation increases and the proportion of flexible conventional generating units decreases, a contribution from the demand side to primary frequency control becomes technically and economically desirable. One of the reasons why this has not been done was the perceived difficulties in dealing with many small loads rather than a limited number of generating units. In particular, the cost and complexity associated with two-way communications between many loads and the control center appeared to be insurmountable obstacles. This paper argues that this two-way communication is not essential and that the demand can respond to the frequency error in a manner similar to the generators. Simulation results show that, using this approach, the demand side can make a significant and reliable contribution to primary frequency response while preserving the benefits that consumers derive from their supply of electric energy. [ABSTRACT FROM AUTHOR]

The authors discuss an article by M. Lavorato and colleagues on imposing radiality constraints in power distribution system optimization problems. They claim that the paper lacks any reference where an alternative mathematical formulation is proposed to deal with transfer nodes or zero-injection nodes. In their opinion, the possibility for transfer nodes is not realistic, being in opposition to the usual operation of the medium voltage (MV) systems where all the transfer nodes are connected to.