Search

Thin semiconductor quantum well structures fused onto LiNbO(3 ) substrates using the epitaxial lift-off (ELO) technology offer the possibility of controlling the surface acoustic wave (SAW) velocity via field effect. The tunability of the conductivity in the InGaAs quantum well results in a great change in SAW velocity, in general, accompanied by an attenuation. We show that an additional lateral modulation of the sheet conductivity reduces the SAW attenuation significantly, enhancing device performance. At high SAW intensity the bunching of electrons in the SAW potential also leads to a strong reduction of attenuation. These effects open new possibilities for voltage-controlled SAW devices. We demonstrate a novel, wireless, passive voltage sensor, which can be read out from a remote location.

Surface acoustic wave (SAW) radio transponders make it possible to read identification codes or measurement values from a remote location. The decisive advantage of these SAW transponders lies in their passive operation (i.e., no power-supply), and in the possibility of wireless installation at particularly inaccessible locations. The passive SAW transponders are maintenance free. Identification marks respond to an interrogation signal with their nonchanging identification pattern. In wireless SAW sensors the physical or chemical properties to be detected change the propagation characteristics of the SAW. SAW radio transponders are advantageously placed on moving or rotating parts and in hazardous environments such as contaminated or high voltage areas. They also can be used for contactless measurements in high vacuum process chambers, under concrete, extreme heat, or strong radioactive radiation, where the use of conventional sensors is complicated, dangerous, or expensive. In this paper we discuss the principles of wireless passive SAW transponders and present a radio frequency interrogation unit and several passive radio SAW sensors developed for noncontact measurements of temperatures, pressures, torques, and currents.

An overview of surface acoustic wave (SAW) filter techniques available for different applications is given. Techniques for TV IF applications are outlined, and typical structures are presented. This is followed by a discussion of applications for SAW resonators. Low-loss devices for mobile communication systems and pager applications are examined. Tapped delay lines (matched filters) and convolvers for code-division multiaccess (CDMA) systems are also covered. Although simulation procedures are not considered, for many devices the theoretical frequency response is presented along with the measurement curve.

The advantages of the coupled-mode (COM) formalism and the transmission-matrix approach are combined in order to create exact and computationally efficient analysis and synthesis tools for the design of coupled surface acoustic wave resonator filters. The models for the filter components, in particular gratings, interdigital transducers (IDTs) and multistrip couplers (MSCs), are based on the COM approach that delivers closed-form expressions. To determine the pertinent COM parameters, the COM differential equations are solved and the solution is compared with analytically derived expressions from the transmission-matrix approach and the Green's function method. The most important second-order effects, such as energy storage, propagation loss, and mechanical and electrical loading, are fully taken into account. As an example, a two-pole, acoustically coupled resonator filter at 914.5 MHz on AT quartz is investigated. Excellent agreement between theory and measurement is found.