Search

This paper proposes a current-fed single-phase inverter without constant intermediate DC link. It eliminates electrolytic capacitor from the DC-link and introduces an intermediate pulsating DC bus. The proposed topology is modular with three full-bridges making it scalable for high-power applications. New pulsating-DC-modulation for back-end pulsating DC-link inverter and secondary modulation (SM) for front-end DC-to-pulsating DC converter is proposed. Soft-switching and device voltage clamping of both primary side and secondary side devices of front-end current-fed full-bridge converter is realized. A rotating partial hybrid pulsewidth modulation has been introduced. One leg of inverter is commutated at a low switching frequency, while the other leg is operated at a high switching frequency for partial period of a line frequency cycle. Thus, switching losses of the back-end inverter are considerably reduced. Rotating mechanism is used to equalize the switching losses of four switches of the inverter. This paper presents detailed operation and analysis of the topology with a proposed modulation scheme. Simulation and experimental results validate the effectiveness and accuracy of the proposed modulation scheme as well as soft-switching and performance of the converter. [ABSTRACT FROM PUBLISHER]

Some electrified vehicles, for example the Toyota Prius, integrate a dc–dc converter between the battery pack and the traction inverter to increase the powertrain efficiency. However, adding this extra converter adversely affects the cost and power density of the powertrain due to the additional components, such as the switches and the inductor, that are expensive and heavy in high-power converters. The concept of the multi-source inverter was previously introduced as an alternative solution to reduce the power rating of the dc–dc converter while keeping similar powertrain performance. In this paper, the implementation of the multi-source inverter in a hybrid power-split powertrain is discussed. The operating modes during both dc–ac and ac–dc conversions are detailed and a prototype is experimentally tested with a load. New control strategies of the proposed powertrain show that three out of five operating modes bring new opportunities in terms of battery charging and power rating reduction of the dc–dc converter. A vehicle-level simulation model is developed in MATLAB/Simulink to quantify the benefits of the proposed topology. Simulations are performed for four drive cycles to compare the power profile of the dc–dc converter of the suggested powertrain with the Toyota Prius. The average power transferred by the dc–dc converter can be reduced by up to 25 $\%$ in most drive cycles tested. [ABSTRACT FROM AUTHOR]